Ensure it is in (Park), wiggle the steering wheel while attempting, or put the door key down and try the ignition...
where is turn signal relay located at 1989 mercury sable
to reset the alarm system for a Mercury Sable when the alarm is causing the car not to start, place the key in the ignition. Turn the key only about halfway and leave it in this spot for 10 minutes before trying to start the car.
put the key in,and turn it.
Push in on the turn signal indicater
Turn the headlight switch on and pull it towards you.
To reprogram the transponder on a 2003 Mercury Sable, you'll need a working key and the vehicle's ignition system. Start by inserting the working key into the ignition and turning it to the "On" position without starting the engine. After about 10 minutes, turn the key back to the "Off" position and repeat this process two more times. On the third cycle, turn the key to the "On" position and then quickly insert the new key within 10 seconds to program it.
the 98 tc manual says: 1. turn ignition on 2. press door unlock 3 times 3. turn ignition off 4. press unlock 3 times 5. turn ignition on. doors should lock and unlock 6. with ignition still on press unlock. If horn chirps you have toggled autolock feature.
To remove a ignition switch from a 1963 mercury meteor you must turn it off then unscrew it.
That means you ignition is lock but its not a BIG problem. Just unlock it.
turn wheel to the left just slightly wheel is in a bind
Dealer Salvage Yard
You need a new psp power sterring pressure switch