That means you ignition is lock but its not a BIG problem. Just unlock it.
Defective ignition switch.
first you pull the plastic rod then turn on the ignition
It sends a power to the starter relay/solenoid to engauge the starter. Know that the ignition switch is not what you put the key in and turn. That is the lock assembly. The ignition switch is located lower down on the steering column.
You turn on power to the accesories, ie radio, power outlet, etc.
you pull out the radio and dash cluster and you will have full access to the ignition just turn it over and un clip the wires
To disable the anti-theft in a 2000 Nissan Maxima, put the key into the ignition, but only turn it halfway. Leave it in this position for several minutes and start the car.
The neutral safety switch is bad, the ignition does not recognize it is in park. Your ignition switch may be bad.
... Turn the key and pull towards the passenger side.
Ignition switch 2002 Chrysler sebring. Original key will not turn? Is there a fuse or replace the switch?
try holding the steering wheel just a bit to one side or the other and you should be able to turn key then
there is no Chevy town and country. its a Chrysler.
Ur life suck that why
change ignition switch and/or tumbler
Yes, the ignition switch must be in the ignition position -not- the accessory position.
Set the multi-information display to TRIP A. Turn the ignition switch off. Press and hold the ODO / TRIP switch, and turn the ignition switch on (IG). After turning the ignition switch on (IG), keep holding the switch for at least 5 seconds.
Defective ignition switch.
99 jeep Cherokee Laredo stay running after turn off the ignition switch?