answersLogoWhite

0

To wire a Prestolite distributor, first ensure the ignition is off and the battery is disconnected. Connect the primary ignition wire from the ignition coil to the terminal marked "B" on the distributor. Then, connect the secondary wire from the distributor cap to the ignition coil's output terminal. Finally, ensure that all connections are secure and that the distributor is properly grounded before reconnecting the battery and testing the ignition system.

User Avatar

AnswerBot

5mo ago

What else can I help you with?

Related Questions

When was Prestolite Electric created?

Prestolite Electric was created in 1911.


Where is the coil wire located on a 1997 Chrysler Sebring LXI 2.5L?

The coil is inside the distributor. There is no coil wire.The coil is inside the distributor. There is no coil wire.


How do you set the air gap on a 81 international 345 engine with a prestolite distribuator?

To set the air gap on a 1981 International 345 engine with a Prestolite distributor, first, remove the distributor cap to access the pickup coil. Use a feeler gauge to measure the gap between the pickup coil and the reluctor; the gap should typically be set around 0.008 to 0.010 inches. Adjust the position of the coil by loosening its mounting screws until the proper gap is achieved, then retighten the screws and reassemble the distributor cap. Finally, ensure the ignition timing is set correctly after making the adjustment.


What fires the distributor?

where does the hot wire come from going to the distributor on a chevy 350


Where is location of coil wires 8N ford tractor?

The coil wire runs from the coil to the center of the distributor cap.The coil wire runs from the coil to the center of the distributor cap.


Is the spark plug wire placement the same on a points distributor as it is on an HEI distributor?

Yes


Where is the location of the timing wire on a 1997 5.0?

It is a brown wire connected to the distributor.


After taking off the distributor wire for a few days my engine is jerking?

Maybe try putting the distributor wire back on and see if the jerking stops.


Does the wire form the distributor go to the pos termial of the coil?

Assuming you have an older vehicle with points, the wire from the distributor goes to the neg side of the coil.


What is the plug wire placement on the distributor cap of a 1996 gmc 5.7?

what is the plug wire placement on the distributor cap of a1996 gmc 4.3 v6?


What is prestolite gas?

Prestolite gas is a brand of propane gas used for various applications such as heating, cooking, and fuel for vehicles. It is known for its high quality and reliability in providing a clean and efficient energy source. Prestolite gas is widely used in residential, commercial, and industrial settings.


How do i wire an hei distributor to a tbi harness?

You can not, it is a complete different type of Distributor. And engine will not run