0
What else can I help you with?
Why don't the dashboard lights work on the Pontiac Montana?
If all of the dashboard lights do not work at the same time on a Pontiac Montana, check the instrument panel relay. The relay is located on the firewall in the engine compartment.
Repair manual for Pontiac Montana Van?
my fuel pump is not work
Will factory tires and rims from a 2001 Pontiac grand am work properly on a 2003 Pontiac grand am?
The factory tires and rims from a 2001 Pontiac grand am cannot work properly on a 2003 Pontiac grand am.
On a 2003 Pontiac Montana the rear brake lights don't work and the bulbs are not burned out?
the control panel on the rear lights goes bad. you can get a new panel on carstuff.com for cheap
Why doesn't the cooling fan work on a 2001 Pontiac Montana?
its a relay switch
Where is the thermostat located on a 2003 Pontiac aztek?
On a 2003 Pontiac Aztek, the thermostat is located near the engine, specifically at the engine's coolant outlet, which is typically connected to the upper radiator hose. To access it, you may need to remove the engine cover and possibly some other components for better visibility and access. Be sure to allow the engine to cool down before attempting any work on the cooling system.
Why does your fan switch only work on 4 on your Pontiac Montana?
blower motor resistor is bad
What vehicle will oil filter QS3980 work in?
1984-1988 pontiac fiero with the 2.5L engine or any pontiac with the 2.5L engine
Will a Chevy van transmission work in a Pontiac trans am?
No, the tranny has to be out of a olds, Pontiac, or Buick to bolt up to a Pontiac engine.
Will a 2003 3.4 L grand am engine swap into 2000 venture?
Short answer, no. A pontiac and GM engine are different. Long story, yes, with a lot of work. Wiring harness and ECU will have to be switched at the very least.
Will parts off of a 1989 Pontiac firebird work on a 1991 Pontiac firebird?
What parts??? Body, engine, suspension???
Where is map sensor 2003 Pontiac sunfire?
The map sensor on a 2003 Pontiac Sunfire is located on the intake manifold, typically near the throttle body. It may be mounted directly on the manifold or attached to a nearby bracket. To access it, you may need to remove some engine covers or components for better visibility. Always ensure the engine is off and cool before attempting to locate or work on the sensor.
