There is no power to the front wheel of a motorcycle but there are several ways that power is transmitted from the engine to the rear wheel. The engine is connected to a transmission which converts engine torque and rpm into a usable and variable gear rotation which is then transferred to the rear wheel by chain, belt, or direct gear drive or automatic transmission. The difference in the size of the front and rear sprockets and the gear ratio in the transmission determine low speed torque and top speed. The most common is chain drive, it is in all off road motorcycles because of its ease of maintenance, durability, and flexibility for suspention travel it is rather noisy though. Belt drive is found in a lot of cruisers like harley Davidson that don't require much suspention travel and where a slightly quieter ride is desireable, Lastly on the luxury bikes you might find where manufacturers have utilized a driveshaft of sorts that is directly connected to the transmission for the quietest ride available.
yes
In 2wd it will free wheel while driving. There is no power being transmitted through it though.In 2wd it will free wheel while driving. There is no power being transmitted through it though.
untrue front wheel
"4x2" means a four-wheeled vehicle in which the engine power is transmitted to only two axle-ends: the front two in front-wheel drive or the rear two in rear-wheel drive vehicles.
Braking power transmitted to the front wheel is high compare to that of rear wheel normally(60:40 or 70:30) in motor cycle.Disc brakes which has high magnitude of braking power compare to that of drum brakes are used in motor cycles to absorb the more braking power.
It means that the truck does not have four wheel drive. The truck is rear wheel drive and is pushed from the back. 4x2 means a four-wheel vehicle in which engine power is transmitted to only two axle-ends: the front two in front-wheel drive or the rear two in rear-wheel drive.
The 2004 Chevrolet Impala is a front-wheel-drive vehicle. This means that the engine's power is transmitted to the front wheels, which are responsible for both steering and propulsion. Rear-wheel drive would mean the power is sent to the rear wheels, and four-wheel drive would typically allow the driver to manually switch between two-wheel drive and four-wheel drive modes for better traction in certain conditions.
coz your car is a wenner
The coefficient of drag of the solid disc wheel is higher than the spoke wheel, therefore the net force on the wheel goes up as the drag coefficient goes up. The rear wheel does not have a significantly greater effect over a spoke wheel, because it is shrouded by other motorcycle parts [rear fenders, chain guards, saddlebags etc]. The front wheel is a different matter because as well as an increase in force on the front wheel, a solid front wheel also moves the center of pressure forward on the motorcycle, which may make the motorcycle harder to control in cross winds.
front wheel bearing bad on a motorcycle
The "FRONT" arrow indicates the recommended rolling direction for the front wheel and respectively the "REAR" arrow is the direction for the rear wheel.
The Harley Davidson Springer is a softail motorcycle that has a springer front end. The springer has an extra spring loaded shaft that helps for the front wheel's suspension.