0
What else can I help you with?
Where is blower motor located on 92 Cadillac eldorado?
Under the dashboard on the passenger side. 3 7mm hexhead bolts.
How many motor mounts are there on the 92 eldorado?
one on the bottom one on the top, the rest bolts onto the transmission
How do you remove the radiator on a 1984 Cadillac Eldorado?
To remove the radiator from a 1984 Cadillac Eldorado, first ensure the engine is cool and disconnect the negative battery cable. Drain the coolant by removing the drain plug on the radiator and then disconnect the upper and lower radiator hoses. Next, remove the mounting bolts securing the radiator to the support, disconnect any transmission cooler lines if applicable, and carefully lift the radiator out of the engine bay. Finally, check for any additional components that may need to be removed, such as the fan shroud, before lifting the radiator free.
How do you remove rear seats on a 1972 Cadillac Eldorado?
Push bottom in then up for bottom. Top has two bolts then lifts up out of clips behind seat
How do you remove the oil pan on a 1997 Cadillac Eldorado one of the bolts is impossible to get to?
i have the same problem on my 97 eldorado. the transmission is too close to the bolt to get a socket around it. you would have to take the whole engine out or take it into a repair shop and be sure to tell them exactly what the problem is so that they dont spend a bunch of time looking for something else wasting your money.
Where is the thermostat located on a 1989 Cadillac Eldorado?
Hope this will help, I replaced mine,88 eldorado, and found it at left end of the top hose, attached by (2)Two bolts. Facing engine,top radiator-hose,follow to the left with point of contact on engine top,secured by with two bolts. Good Luck
How do you change the EGR valve on a 1989 Cadillac Eldorado?
Itt is not a hard job. Simply remove the vacuuum line then the 2 bolts that hold it on. Clean the carbon from the manifold where it bolts. Replace the vvalve and instaall the vac line. GoodluckJoe
Can the flywheel be removed and replaced without removing engine or transmission i'n 1978 Chevy 350 motor?
NO. You will have to remove all the transmission bolts and slide the transmission back enough to get a wrench and your hand between the engine and transmission to remove the fly-wheel bolts.
How do you remove the transmission from 1997 Honda Passport?
I have removed all bolts an linkage, I tried separating the transmission and transfer case and can't get it to come apart
Is it possible to tighten Flywheel on a 2001 Chevy Blazer without removing the housing or starter?
NO. You will have to remove the transmission bolts and move the transmission back alittle after you have removed the driveshaft,transmission lines,crossmember bolts,starter,flywheel dust cover,front driveshaft,torque converter bolts. NO OTHER WAY.
How do you remove 1949 Cadillac door handles?
Wow, a 49 caddy!!!!! The majority of door handles from this era were bolted on from inside the door. The door liner must be removed to access the bolts. I am not 100% sure about your 1949 Cadillac, but suspect it is the same.Wow, a 49 caddy!!!!! The majority of door handles from this era were bolted on from inside the door. The door liner must be removed to access the bolts. I am not 100% sure about your 1949 Cadillac, but suspect it is the same.
How pull heads off 1998 eldorado?
unscrew the bolts
