To reset the computer on a 2000 Dodge Ram, you typically need to drive the vehicle for about 50 to 100 miles after clearing any trouble codes. This distance allows the engine control module (ECM) to re-evaluate sensor readings and adapt to driving conditions. However, if you're looking to reset the check engine light specifically, you can also disconnect the battery for about 15 minutes, which may suffice without driving.
5 to 6 miles at the most.
To reset computer on dodge caliber. remove the dodge caliber, remove the negative and positive cable from the battery. You can then reset your computer.
drive it about 30 to 50 miles,you reset the computer when you replaced the battery. What you want is info back in the computer ,that is why a minimum of 30 to 50 miles must be driven to put info back in.
no after changing drive vech for 3 miles
Dodge does not use inertia/reset switches. The fuel system is computer controlled with relays.Dodge does not use inertia/reset switches. The fuel system is computer controlled with relays.
Dodge does not use inertia/reset switches. The fuel system is computer controlled with relays.Dodge does not use inertia/reset switches. The fuel system is computer controlled with relays.
No
A Dodge Intrepid does not have a reset switch. The fuel system is computer controlled.
Dodge does not use inertia/reset switches. The fuel system is computer controlled with relays.
Dodge doesn't use inertia/reset buttons. The fuel system is computer controlled with relays.
You don't.
With a scan tool.