0
What else can I help you with?
What fluid goes in a torque conyerter And how much?
The torque convertor uses transmission fluid and is filled by the transmission's internal pump. When you start out with a new convertor, it's a good idea to put a quart of fluid in before installing it on the transmission. When the transmission dipstick shows full, the convertor is also full. An empty torque convertor holds several quarts, depending on the size.
92 vigor im having your transmission rebuilt your mechanic says that you also have to have the tur converter replaced What is that?
The torque convertor acts as an automatic clutch for the transmission. If you are replacing the transmission, I would recommend replacing the convertor too, especially if the trans fluid is burnt or contaminated. If you have a manual transmission, run, there is no torque convertor :)
How do you align a new torque converter on a 1993 Corolla to the drive plate?
It is easier to do if you install the torque convertor to the transmission and then attempt to bolt it to the flywheel. You will have to turn the convertor or flywheel to line up the bolt holes.
Is draining the transmission the same as flushing it?
no there is still fluid in the torque convertor,lines & cooling tank
Where is the torque convertor on a 91 Ford Taurus?
Rear end of the engine - front end of the transmission
Do you torque the flex plate to convertor on c4 automatic transmission?
All fasteners have a torque spec suggested by the manufacturer. You will find that information in the shop manual for the vehicle.
Where are the casting numbers for a 350 turbo transmission for Chevy?
Pull the torque convertor out, they are on the front of the tranny inside the bell housing.
Where is the torque converter on a Chevrolet Astro 98?
In a 1998 Chevrolet Astro, the torque converter is located within the transmission assembly. Specifically, it is situated between the engine and the transmission, housed inside the bell housing of the transmission. To access the torque converter, you typically need to remove the transmission from the vehicle, as it is not externally accessible.
Your 98 contour2.0 zetec automaticshudders real bad when in any gear except park esp when stopped at a redlight any ideas?
this usually indicates an internal transmission problem, but possibly only the torque convertor, or torque convertor lockup solonoid, also, you want to check to make sure all of the motor & transmission mounts are good.
What happens when a torque convertor goes out?
There is nothing inside a torque converter to go out. if the transmission fails to pull it may be, fluid level, front pump, control system or clutches burned.
What will cause a 1998 Ford Expedition transmission to not run when put into gear or reverse?
probly a bad torque convertor. if a dealers does it figure a grand for it.
Do you have a Picture or diagram of a 2003 Chevy Tort Converter Clutch. Mel Glenn AL?
The Torque convertor clutch is actually a part of your torque convertor. It is electronically controlled when is is activated and when it is not. Usually it will come on at highway speeds in the top gear to increase fuel efficiency and decrease torque convertor slip. It basically locks your engine to transmission to create a "direct drive" where the rpm in your engine is the rpm in your transmission. There isn't really a diagram for the clutch. I guess im not really sure why your needing a diagram for it- Please explain
