0
What else can I help you with?
How much oil does a 1997 cadillac northstar engine hold?
7qts
How much oil is needed for a 1997 Cadillac Northstar 32 valve engine?
The oil capacity of the 4.6L 32 valve Northstar in a 1997 Cadillac is 7.5 quarts.
How much will a new engine cost?
Need to know the year, make, model, engine size and if you want to know the price of a new engine only or a new engine plus installation.Hu 2005 Cadallic Deville Northstar Remanufactured long block engine only, aprox $4600.
How much horsepower does a 2000 Cadillac Eldorado northstar have?
The 2000 Cadillac Eldorado, equipped with the Northstar V8 engine, produces 300 horsepower. This powerful engine is known for its smooth performance and advanced engineering, contributing to the Eldorado's reputation as a luxury coupe.
How much horsepower does a 1999 Cadillac sts have?
Northstar engine is rated at either 280 for the SLS or 300 for the STS for 1999.
How much oil does a 2009 Cadillac need?
Well, if it is a Deville with the Northstar 4.6L engine, the manual calls for 7.5 quarts with filter.
How much to rebuild and install northstar 32v transmission?
dont waste your money the northstar motors are crappy
Where is the starter motor located on a 1995 northstar engine and can it be removed easily?
where is the starter motor located on a 1995 northstar and can it be removed without much trouble Its under the intake manifold on the driver side. just remove the intake cover, then the upper intake and there it is. good luck.
How much oil does a north star take on an oil change?
Usually it will take about 7 quarts on a Northstar V8. Note of interest...Some Northstars have a tendency to leak when full of oil. Because of this some Northstar owners only put in oil to the middle of the low and fill lines on the dipstick and this seems to solve that little problem. Other than that the Northstar is an amazing engine.
How much does water cost?
Water cost £1.00
How much to fix a head gasket for Cadillac Deville northstar?
HG replacement on a Northstar is not a trivial job. The engine should be pulled. Re-tapping the head bolt holes MUST be done. At a typical dealer, it's a $3500-$5000 job, with I believe a 40-hour book.
How much does a 4.3L v6 engine cost?
it cost 1000
