It's not a real expensive repair, but labor costs are all over the place-for this go to a hole in the wall shop to get it done since it takes no special skills or equip. the mount is anywhere from 30-50.00 and you are looking at about 1.5 hrs labor (give or take) You can even do this yourself, all they do is loosen a few items to allow slight movement then jack up engine a few inches usually by balancer or using a houst to slip it in.
About $300.
You have to take the tire off and go in from there.
I had it done at the dealer, it was $260 for front mount on passenger side.
Remove the radiator overflow resevoir(the clip will probably break, no big deal), jack the engine up a few inches with a floor jack, remove the bolts holding the motor mount on and replace.
To replace the motor mount on a 1996 Z28 Camaro, first, lift the vehicle securely and remove the front wheels for better access. The passenger side motor mount is located between the engine and the frame, accessible from above or below. Support the engine with a jack, remove the old mount's bolts, and install the new mount in reverse order, ensuring all bolts are torqued to specifications. Finally, lower the vehicle and check for proper alignment and clearance.
in removing motor mount what bolts need to be removed. This is a 1998 biuck regal 3.8L, and I am not sure how to remove the motor mount.
motor mount motor mount
You need to put the car on jack-stands, remove the wheel and the splash pans, remove the bottom fastener, lift the engine and remove the mount, replace in reverse.
You can replace your 1995 Chevy Corsica motor mount by loosening the motor mount retaining bolt. Jack the engine up approximately 3 inches. Remove the motor mount retaining bolt and the motor mount bushing. Put the new motor mount bushing in and reverse the process.
Remove the old mount & replace with the new.
There is no fixing a broken motor mount. Replace them with a new ones.
You will have to replace the entire motor mount.