0
What else can I help you with?
How do you replace a timing chain on a 1998 Oldsmobile delta 88?
How to change a timing chain in a 1998 Oldsmobile delta 88
How can you stop the sonsor light for breaks on an 1994 Delta 98 Oldsmobile from coming on?
Check the level of brake fluid in the master cylinder Make sure that the parking brake is released completely
Why does your delta 88 Oldsmobile emergency brake light keep coming on?
Frozen cable not fully releasing? Bad switch at top of emergency brake pedal? Low brake fluid level in master cylinder?
How do you replace a transmission seal on 1985 Oldsmobile delta 88?
You gotta use tools.
What is the firing order for a 1989' Oldsmobile Delta 88 3.8L?
The firing order for a 1989 Oldsmobile Delta 88 3.8L V6 is: 1-6-5-4-3-2 The #1 cylinder is located in the RIGHT FRONT.
How do you remove the tail light from a 1977 Oldsmobile delta 88?
The light bulb or the taillight lens? Open the trunk to replace the bulb.
How do you tune-up a 1995 Oldsmobile Delta 88?
You don't. That is a ripoff. Testing and replace out of range sensors is a more reasoable projct.
Where is the OBDII on a 1996 Oldsmobile Delta 88?
left of the console area under left side of dash. Rick ASE L-1 Master TransMichigan.com
Can you use 134a freon in a1991 Oldsmobile delta 88?
Only if you replace the Dryer, install adapters on the lines, and use compatible oil.
How do you replace the fuel filter on a 1989 Oldsmobile Delta 88?
I have a Delta 88 and its located about 18 inches in front of the rear tire on the driver side, its right under the second door of the driver side.
What does fuse 17 control in 1993 delta 88 Oldsmobile?
Fuse 17 in a 1993 delta 88 Oldsmobile controls the air conditioner
How do you get access to the spark plugs in a 1998 Oldsmobile Delta 88 to replace them?
To access the spark plugs in a 1998 Oldsmobile Delta 88, first, open the hood and locate the engine. Remove any necessary components that may obstruct access to the spark plugs, such as the engine cover or ignition coils. The spark plugs are typically located on the engine's cylinder head, so you may need a ratchet and socket to remove them. Ensure the engine is cool before starting the replacement process.
