0
What else can I help you with?
What is the general horsepower of a 351 Windsor engine bored 30 over?
it depands on the camshaft and heads. with 30 over windsor it should make at least 370 horsepower with aftermaket camshaft
How much horsepower does a stock 1978 351 Windsor have?
It depends on what vehicle it was orriginally installed into, And the intake, Carb, Heads, The factory had a couple of different power ratings for the motors. Most likely around 200 hP.
What is the torque spec for the intake manifold bolts on a 351 windsor?
With cast iron heads it is 25 ft-lbs.
How can you add horsepower to a 1986 caprice with a 305?
carb, cam, intake, headers, heads, msd igntion, or a 350
How many hoser power will you get by boring your 350 030 adding better heads with headers and high rise intake?
It's all about the combination, so it's impossible to answer the question. However, it's reasonable to say that the overbore should produce at least 2 or 3 horsepower, the headers could add 10 horsepower, the intake, 5-10 horsepower, and the heads could add anywhere from 10-100 horsepower.
Will a 302 intake and heads fit on a 351 windsor?
Yes, a 302 intake and heads can fit on a 351 Windsor, but modifications may be necessary. The 351 Windsor has a larger cubic inch displacement and different port configurations, so while the physical mounting may align, performance may not be optimal. Additionally, you may need to consider the throttle linkage and other components to ensure proper fitment and function. It's often more effective to use components designed specifically for the 351 Windsor for optimal performance.
How do you make 400 horsepower with the 351 windsor engine?
ported heads, 4 bbl carb nice cam, and if you want to chance it stroke it, i have a little tip about strokin a 351w
What are 202 Chevrolet Heads?
202 refers to the intake valve size, as in 2.02 inches, upgrading to 202 heads is a very common way to gain horsepower, but usually requires upgrading the intake (better intake manifold and a better carb) and installing headers, to make the most of it. even installing a new highperformance camshaft
Can a intake manifold from a 351 fit a 302 with 351 heads?
Yes, a 351 windsor intake will fit a 302 engine as long as it is a 1976 or above. Although you will have to change the bolts, but yes it will work. 38 year certified mechanic
Will gt40 heads work on a 351 windsor?
yes, gt40 heads should work on a 351 windsor. they should work on any small block ford from a 260 to the 351 windsor. Good luck!
What would the estimated horsepower be on a 383 with cam headers pistons edelbrock intake and carb?
without swaping heads or getting head work done your looking at approximatly 400 hp depending on the cam and intake and carb match.
Is there an adapter for this I Want to put a 78 350 into 96 Tahoe but intake is vortec is there an adapter or different intake that you can get?
there is no adapter. vortec heads were cut at a diffrent slope than standard sbc heads. you can swap the heads on the 78 350 for vortech heads or get a multipoint fuel injection intake for a 85 - 95 350. you can get the intake from summitracing.com You will have to swap the heads and the intake
