0
A 2008 Jeep Commander typically requires about 6 quarts of engine oil with a new oil filter. It's important to use the recommended oil type, which is usually 5W-20 or 5W-30, depending on the engine variant. Always check the owner's manual for the specific requirements for your vehicle.
What else can I help you with?
How much oil do you need for a 2007 jeep commander?
5.7L 7 quarts 4.7L 6 quarts 3.7L 5 quarts
What to do in 2008 jeep commander say damaged key and wont start?
If your 2008 Jeep Commander displays a "damaged key" message and won't start, first try using a spare key if you have one, as the original key's chip may be malfunctioning. If the spare key doesn't work, check the ignition system and battery for any issues. You may need to reprogram the key or replace it if it's damaged. If problems persist, consult a professional mechanic or a Jeep dealership for assistance.
How much crank power does a Jeep Cherokee need?
a jeep Cherokee need 220 volts to run
Service 4wd system for jeep commander?
The system has detected a malfunction and set a code. You will need to have it checked with a scan tool.
What does it mean when my jeep commander shakes while braking a high or low speeds?
Your brake rotors or drums are warped and need replaced.
How much oil does a jeep 3.7 need?
5qts
Where is the starter on your 2006 jeep commander?
On a 2006 Jeep Commander, the starter is located on the passenger side of the engine, mounted to the transmission bell housing. To access it, you typically need to raise the vehicle and remove the protective cover if equipped. It's advisable to disconnect the battery before attempting any work on the starter to ensure safety.
Where is the cabin filter for a 2007 jeep commander located?
The cabin filter for a 2007 Jeep Commander is located behind the glove compartment. To access it, you need to remove the glove compartment by either detaching it or lowering it fully, which allows you to reach the filter housing. Once you locate the filter cover, you can remove it to replace the cabin filter.
Do you need to drain the air conditioning when removing the heater core in a 2008 Jeep Liberty?
YesYes
Where is the circuit breaker located for the sunroof in a 2007 Jeep Commander?
In a 2007 Jeep Commander, the circuit breaker for the sunroof is typically located in the fuse box under the dashboard on the driver's side. To access it, you may need to remove the cover of the fuse box. Check the owner's manual for the exact location and designation of the circuit breaker related to the sunroof.
Where is the keyless entry module on a 2006 Jeep Commander?
The keyless entry module on a 2006 Jeep Commander is typically located under the dashboard on the driver’s side. You may need to remove some panels to access it, as it is mounted on or near the fuse box. It's important to consult the vehicle's service manual for specific instructions and diagrams for easier access.
Where is the ecm on an 07 jeep commander?
The Engine Control Module (ECM) on a 2007 Jeep Commander is located in the engine compartment, specifically on the driver's side near the front of the vehicle. It is typically mounted near the fuse box and can be accessed by removing the protective cover. If you need to service or replace it, ensure the battery is disconnected to avoid any electrical issues.
