0
What else can I help you with?
How do you change ignition Lock Cylinder in 1990 Jeep Wrangler?
Use only Duncan Hines cake mix for this 2 eggs and 1/2 cup vegtable oil rub it on the cylinder start the engine that should work
What is the correct running temperature for a 2002 Jeep Wrangler 6 cylinder?
210 deg F, it should be directly verical on the engine temp gauge.
What type of oil should be used for 2000 jeep wrangler 4 cylinder?
10w30
What is the average miles you should expect to get on a 4 cylinder Jeep wrangler?
50 miles
What oil should be use on a 1992 4 cylinder jeep wrangler?
10w3010w30
Should an idler pulley in a 97 jeep wrangler 4 cylinder be rotating?
If there is a belt there absolutely!
What should the oil pressure be on a 1997 jeep wrangler 2.5 liter 4 cylinder engine?
The oil pressure for a 1997 Jeep Wrangler with a 2.5-liter 4-cylinder engine typically ranges between 25 to 65 psi when the engine is running at normal operating temperature. At idle, the oil pressure should remain above 10 psi. If the oil pressure falls significantly below these levels, it may indicate a problem with the oil pump, oil level, or engine wear. Always refer to the vehicle’s service manual for specific guidelines and troubleshooting.
Will a transmission and transfer case from a 95 wrangler fit in a 93 wrangler?
Should work provided it is the same engine set up.
What type of oil should be used for Jeep Wrangler?
I know the 4.0l 6 cylinder suggests 10w30 motor oil, but I'm not completely sure for the 2.5l 4 cylinder. 10w30 would make sense for that engine, but check your owners manual for more clarification.
What should you do when find water in the engine oil of an outboard engine?
First thing would be to change the oil and filter. Perform a compression and cylinder leak down test on each cylinder, to determine how, and where, the water intrusion occured.
What is the towing capacity of a 1988 4.2 liter Jeep Wrangler?
You should not tow more than 2,000 pounds in a 1988 Jeep Wrangler. This is considering the engine is a 4.2 liter engine.
How long to change head gasket in Pontiac grandam?
depends on what engine the 4 cylinder should take a day if you have all the tooling
