answersLogoWhite

0


Best Answer

Cost on replacing ball joints on a 2001 Buick lesabre

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How much should it cost to replace ball joint for buick lesabre?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the lower ball joints in a 1987 Buick LeSabre?

You need a ball joint press to do that job. Remove old ball joint with sledge hammer and press new on into control arm.


Where is the oil filter located on a 1993 Buick LeSabre?

Bottom of engine, passenger side, next to CV joint.


What causes a metal sound when making left turns only in a 1992 Buick LeSabre?

CV Joint going out


How do you replace the u joint on a 1995 Buick Roadmaster drive shaft?

very carefully!


What causes a clicking or chirping sound from the wheel well area on a 2003 Buick Lesabre?

Possibly a defective CV joint if it happens in turns, or if it only happens when you apply the brakes, then it needs new pads.


What causes a pop-like noise when accelerating on a 1992 Buick LeSabre?

Possibly worn CVC joint. Have the CVC joints inspected. It might be that your motor mounts are broked and the motor is lifting up and slaming back on the chasey


Replace cv joint on Lincoln LS?

don't replace the joint. replace the axle


Why does buick regal right turn clicking noise replaced cv axle bearing cannot duplicate noise on lift?

Did you replace the CV joint itself? If the boot is torn then that is your problem.


How do you repair 1998 buick park ave rack and pinion?

The repair will depend on the problem. If there is an internal issue then replace the rack. If it is a leak ow worn joint in the steering then that can be replaces separately.


How to replace the CV Joint on a 1987 Buick LeSabre?

Loosen the hub nut in the center of the wheel. Then raise the car and take off the wheel. Finish taking off the hub nut. Take of the brake caliper and rotor. Remove the stabilizer bar from the lower arm. Seperate the lower ball joint from the steering knuckle. You may have to use a puller to push the cv axle out of the hub. Then jently pry the other end out of the transmission. That is how you take the halfshaft(aka cv axle)off. I don't know if your going to rebuild the joints or change the whole axle, but I just changed the whole axle on my 87 LeSabre. It just seemed alot easier.


How do you replace a CV joint on a 1992 Chevy pickup?

how do you replace a CV joint on a 1992 Chevy pickup?


How do you replace a cv joint on a 2000 Subaru Outback?

how do you replace the drivers side drive shaft and cv joint?