0
well I'm having the same problem with my 2004 Ford Explorer and Ford told me it will cost any where between 700.00 and 1800.00 dollars...
What else can I help you with?
How do you replace an electric blend door in a Chevy blazer?
Remove the dash assembly to gain access to the blend door actuator.
Chevy blazer 1999 temperature blend door?
The blend door actuator can go bad. Big job to replace it. Dash assembly must be removed to gain access to it.
How do you replace blend door on rear ac on 98 Chevy venture?
To replace the blend door on the rear AC of a 1998 Chevy Venture, start by removing the rear AC unit from the vehicle. This typically involves taking out the access panel and disconnecting any electrical connectors and ducts. Once the unit is out, you can access the blend door and replace it with a new one. After installing the new door, reassemble the AC unit and reconnect everything to ensure proper function.
How do you replace blend door actuator on a 1997 Chevy s10 pickup?
Unfortunally you need to remove the entire dash assembly in order to gain access the the blend actuator. Consider replacing the heater core while your in there only because the amount of work involved to do it later if it should leak.
How do you replace blend door actuator on 97 ford expedition?
How do i replace blend door motor
How difficult is it to replace the blend door on a 2007 Chevy Equinox?
You have to take the front dash apart almost to the firewall. A lot of 5,8and 10mm screws. Not a job for a DIY'er.
How do you replace blend door actuator motor on 1999 ranger?
how to replace a blend door actuator on a 1999 ford ranger
How do you replace a blend air door on a 2000 Pontiac Bonneville?
how do you replace a blend air door assembly on a 2000 pontiac bonneville
Where is the Tahoe blend door actuator?
The blend door actuator on the late model Chevy Tahoe is located behind the dash in the glove box area. Broken blend doors and broken blend door actuators are a very common problem among Chevy Tahoe, Suburban, and Silverado models. Typically, to repair a broken blend door, a mechanic will disassemble the dash and replace the plenum box. It is an expensive and labor intensive repair. There are also some DIY solutions such as the heatertreater that provide hardware and instructions for performing the repair by removing the glove box rather than the entire dash. It is worth looking into if you think you have a broken blend door.
What causes a knocking noise in the heater box in a 1991 Chevy silverado?
the blend door actuater is more than likely the cause of the noise.....very common....can go in behind the glove box to replace it.
How do you replace a blend door on a Chevy Express?
depends on which door your talking about but its located under the dash pad on the passenger side up against firewall and requires you to remove the entire dash and tilt it forward and down
How do you replace the blend door on a 2002 mercury mountaineer?
If you do a Google search on Ford Explorer blend door there are lots of articles
