answersLogoWhite

0

The cost to repair or replace the intake manifold on a 2001 Mercury Sable typically ranges from $500 to $1,200, depending on labor rates and whether you choose an aftermarket or OEM part. Labor costs can vary based on your location and the shop's hourly rate. Additional expenses might arise if there is damage to related components or if additional parts need to be replaced during the repair. It's advisable to get a detailed estimate from a trusted mechanic for the most accurate pricing.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

Where is the coolant temperature sending unit on a 97 mercury sable?

The coolant temperature sending unit on a 97 Mercury Sable is in the engine compartment. It is located on the intake manifold.


Where is the intake manifold runner control on a 99 mercury sable?

The intake manifold runner control (IMRC) on a 1999 Mercury Sable is located on the intake manifold itself, typically towards the front of the engine. It is part of the assembly that adjusts the airflow through the intake manifold to optimize performance at different RPMs. To access it, you'll need to remove any components obstructing the manifold, such as the air intake duct. Always refer to a service manual for specific details and safety precautions when working on the engine.


Where is the iat sensor plug on a 2002 mercury sable?

Usually located in the air intake tract between the air box and throttle body, or even on the upper intake manifold.


What does a code p1518 mean on 99 Mercury Sable?

Trouble code P1518 means: Intake Manifold Runner Control Stuck Open (Bank 1)


How do you change sparkplugs in a Mercury Sable?

well i have a 98 sable with the duratec 24v v6 and everyone says remove the intake manifold-well folks dont do that cuz i just removed the 4 bolts holding in my disributer and that gave me acces to the back plugs! saved me time and money rather then removing intake manifold! took me bout an hour and i was done!


Where on a 1994 mercury sable wagon with 3.8 liter engine where is the pcv located?

the PCV valve will be lacated in the valve cover next to the firewall. It will be in the top of the valve cover and have a rubber vacume hose leading under the upper manifold to a port on the intake manifold


Where is the coil located in a 2001 Mercury Sable?

on the back of the engine u have to remove the intake to get to it


Where is the throttle body intake on a 1999 mercury sable?

The air intake filter assembly would be connected to the throttle body.


How much should you have to pay to repair your transmission on a 2002 mercury sable?

$1100 to $1400


Where is the knock sensor in 99 Mercury sable?

In a 1999 Mercury Sable, the knock sensor is typically located on the engine block, near the intake manifold. It is usually positioned on the driver's side, towards the rear of the engine. To access it, you may need to remove some components for better visibility and reach. Always refer to the vehicle's service manual for exact locations and procedures.


What happens to a 2001 Mercury Sable when the Manifold Gasket is unsealed?

If it is the intake manifold, there will be vacuum leaks, backfire, and poor performance. If it is the exhaust manifold, you will have loud exhaust noise which may warrant a citation - also, emissions control laws will be violated. Take the manifold ro a shop where it can be re-surfaced or try to find a product at your local auto parts store that will help seal the manifold. - Good luck.


How large is the fuel tank in an 1989 Mercury Sable?

According to my Chilton's Auto Repair Manual : For a 1989 Mercury Sable : ( 16.0 U.S. gallons , or the optional extended range tank which is 18.6 )