How to bleed brake on 1993 sunbird?

Answer 1

Manual brake bleeding is the most common method of bleeding brakes; however, you will need to enlist the help of an assistant. With your assistant sitting in the driver's seat, REPEAT the following six steps a number of times on each brake until you are sure there is no air trapped in the system. Use a narrow block of wood behind the pedal to prevent it from travelling all the way to the floor. Lastly, place a three foot piece of vinyl hose on the end of the bleeder screw to direct old fluid into a plastic container. Start at the Right Rear wheel, then LR, RF, and end up at the LF. 1.Instruct your assistant to pump the brake pedal for twenty seconds 2.Instruct your assistant to press and hold the brake pedal firmly 3.Open a bleeder screw and let the air and old fluid escape 4.Close the bleeder screw 5.Instruct your assistant to release the brake pedal, ( CAUTION: Instruct the assistant to only release when instructed to do so by you) 6.Wait ten seconds