From inside the trunk.
See the answer for the 90 model. Should be the same
remove the 2 bolts on the outside of the lense then pull the assembly out.
Replace the fuses if they go out its a short. Good luck finding that
because you ugly alternater.
To change the rear window center brake light on a 1997 Geo Prizm, first, open the trunk and locate the plastic cover or trim panel that conceals the brake light assembly. Remove any screws or clips securing the cover, then gently pull it away to access the brake light. Twist the bulb socket counterclockwise to remove it, replace the old bulb with a new one, and reassemble everything by reversing the steps. Make sure to test the new bulb before securing the cover completely.
it is in the trunk you just turn and pull the light out of the socket and the light bulb is a 194 i do believe
on my sons 95 prism i had to loosen the nut on the brake light switch and turn it in a couple turns then retighten the nut, works fine
Be sure the dash light dimmer switch is not turned off. Check the fuses.
# Preparation For Brake Pad Replacement # Remove the Wheel # Unbolt the Caliper # Remove the Old Brake Pads # Compress the Brake Piston # Re-Install the Brake Caliper
If the brake light in your 2000 Chevy Prizm stays on, it could be due to a few reasons. Common causes include a faulty brake light switch, which may be stuck in the "on" position, or a malfunctioning relay. Additionally, a short circuit in the wiring or a blown fuse could also keep the light illuminated. It's best to inspect these components or consult a mechanic for a thorough diagnosis.
1999 Chevrolet Prizm brake or tail light bulb lamp replacement procedure: Purchase the correct replacement brake or tail light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake and tail light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake and tail light bulb lamp replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).