The tail light is held on by two screws and two pins. You will see the two screws when you open the back hatch. The two pins are on the opposite side of the tail light in the same general position as the screws. After you remove the two screws, you will find that the tail light assembly can be rocked a little but is still firmly attached. Proceed carefully as you can break the pins since they are only made of plastic. Gently pull the side of the tail light with the screws toward you about 1/8 of an inch. At the top center of the tail light you should now be able to slip you finger tips in to the opening. The plastic is a little sharp so use caution. Gently pull the tail light straight back towards you. You will feel the pin release. At that point you will understand how the whole thing goes together. To release the bottom pin you will need to slip a flat head screwdriver between the tail light and the metal vehicle body. With gentle prying pressure you will feel the bottom pin release. The assembly containing the bulb releases after about one-third of a turn. The bulb pulls easily from the socket with light pressure.Each bulb socket has differently keyed tabs so you cannot insert the wrong socket in the wrong lens portion (e.g. tail light vs turn signal).
The tail light assembly goes back together easily and is done in reverse. You will hear the pins click when they have reattached. It only requires light pressure. Then just reinstall the two screws. Don't over tighten the screws as you can crack the plastic. Open back door unscrew the 2 screws and pull the whole Tail light out
3157LL
how do you change tail light cover on a 1994 ford ranger
To change the brake light on a 2007 Ford Escape, first, open the rear hatch and locate the tail light assembly. Remove the two screws or bolts holding the assembly in place, then gently pull the assembly out. Twist the bulb socket counter-clockwise to remove it, replace the old bulb with a new one, and reassemble the tail light by reversing the steps. Finally, test the new brake light to ensure it works correctly.
Call 3 Chevy owners and promise them they can ride in the back seat. If you mean a headlight, they screw in from the rear of the assembly. The tail lights are similar, but you have to remove the entire light to access them.
Replace the whole light assembly Their are no bulbs it is neon light
To change the tail light on a Ford Fusion hatchback, first, open the trunk and locate the tail light assembly. Remove the screws or clips securing the assembly, then gently pull it out. Disconnect the wiring harness and replace the burnt-out bulb by twisting it counterclockwise. Reassemble the tail light by reconnecting the wiring, securing it back in place, and testing the new bulb.
Sedan or hatch makes a difference
To change a tail light on a 2010 Ford Focus, first, open the trunk and locate the tail light assembly. Remove the screws or clips securing the assembly, then gently pull it out. Disconnect the electrical connector and replace the burnt-out bulb by twisting it counterclockwise. Reassemble the tail light by reversing the steps, ensuring everything is securely fastened before closing the trunk.
Hey Jesse==You have to take the tail light completely off. The bulbs go in from the back Good Luck Joe
Raise the back hatch there is two screws that hold the tail light on (2002 ford explorer) remove the tail light and twist out bulb housing , pull release clips and remove bulb. Install bulb in reverse.
How do you change the tail light on a 2001 toyota sequoia
how to change tail light bulb on Toyota sequoia