$9022
The EGR Valve is located in the engine compartment on the Ford Focus. The EGR Valve is set almost dead center into the top of the motor. The EGR Valve looks like a small carburetor with caps on the top and sides.
the egr sensor is located on the engine compartment firewall next to the egr solenoid
It is just below of the fuel filter
There are two types of mountings for the 2000-2003 ford focus. See the article at this site: http://autorepair.about.com/library/a/1i/bl718i.htm
look at the focus fanatics forum... this thread should help http://forums.focaljet.com/spi-tuning/503448-egr-tube-sheared-header.html
You should unplug the wire connected in the EGR then remove the EGR From the side of the engine. The EGR is located on the driver side towards the firewall about 8 inches above the exhaust. You will need a wrench to remove the EGR. To clean the EGR it is suggested to us brake clean and spray into the EGR while the EGR is removed. Be very careful while cleaning if you use a brush. You can cause damage. I have cleaned them before and it is actually very easy you just need to be careful.
To clean the EGR passages on a Ford Escape, first, disconnect the battery and remove the EGR valve. Use a suitable cleaner, such as throttle body or carburetor cleaner, to spray into the EGR passages, allowing it to soak to dissolve carbon buildup. A flexible brush or pipe cleaner can help scrub the passages gently. After cleaning, ensure everything is dry and reassemble the components before reconnecting the battery.
The egr valve is located right under the air intake line right behind the center of the motor by the fire wall
To change the EGR valve on a 2001 Ford Focus, first, disconnect the negative battery terminal to ensure safety. Remove any necessary components obstructing access to the EGR valve, such as the air intake hose. Then, detach the old EGR valve by unscrewing it from its mounting position and disconnecting the electrical connector and vacuum hoses. Finally, install the new EGR valve, reconnect the hoses and electrical connector, and reassemble any removed components before reconnecting the battery.
To clean a plugged EGR orifice on a 2005 Ford Freestar 3.9, first, disconnect the battery and remove the EGR valve from the intake manifold. Use an EGR cleaning solvent or carburetor cleaner and a small brush to gently scrub the orifice and remove any carbon buildup. It's important to ensure that all debris is cleared before reassembling. Finally, reattach the EGR valve and reconnect the battery, then start the engine to ensure proper operation.
how do you clean a egr valve on a vauxhall zafira 1.6