You should unplug the wire connected in the EGR then remove the EGR From the side of the engine. The EGR is located on the driver side towards the firewall about 8 inches above the exhaust. You will need a wrench to remove the EGR. To clean the EGR it is suggested to us brake clean and spray into the EGR while the EGR is removed.
Be very careful while cleaning if you use a brush. You can cause damage. I have cleaned them before and it is actually very easy you just need to be careful.
what all i need to take a water pump on a 99 Chevy blazer what all i need to take a water pump on a 99 Chevy blazer what all i need to take a water pump on a 99 Chevy blazer what all i need to take a water pump on a 99 Chevy blazer
2002 blazer want take gas
take it to a Chevy place
take it to a good mechanic
take it to get fix
With a wrench...... :-)
You take it to an auto shop and have them do it
If the Blazer is gasoline powered the antifreeze can be any kind that is for sale for gasoline powered vehicles.
Take it to a garage that does alignments.
5 quarts 5W30
take the old one off
Originally it would have had DexCool.
You have to take the engine out, unfortunately.
Remove the calipers and the disk will pull right off
Dot 3 will be just fine.
You have to take the door apart
A NAPA 1040 or the NAPA 1036 will do.
A 3/8" Allen wrench.
NO..... It is not in the way, it is just a tight fit.
Blazer does not take off like it should. sluggih slow take off then after it gets going it does wee.
i need the firing ordere for 4.0 BMW
16 gallons give or take a few tenths