Fixing the heater contol valve is very simple, however, what i might say could be totally different than what you need. I have a 1987 Jeep Cherokee Pioneer 4.0 and my heater control valve went bad and started leaking coolant like crazy. This is a very common problem with these older Jeeps. luckily, it's an easy fix. What you have to do is go to your local parts store (Schuck's/Checker/Krager, Napa, Auto Zone, O'Reilly, whatever) and ask for a heater control valve for your application (year, make, model). then it's just a matter of locating the valve (between the coolant reservoir and heater core) undoing a couple hose clamps, taking out the old one and putting in the new one. very simple. I hope this was helpful.
No, it is not required. You can remove it and splice the heater hoses together.
To fix the heater control valve in a Jeep Cherokee, first, locate the valve, typically found near the firewall on the passenger side. Disconnect the battery, then remove any necessary components for access. Detach the old valve from the heater hoses and electrical connections, and install the new valve in reverse order. Finally, refill the coolant if necessary, reconnect the battery, and check for proper function of the heating system.
The heater control valve on a 1995 Jeep Cherokee Laredo is typically located near the firewall, on the passenger side of the engine compartment. It is connected to the heater hoses that run into the cabin for heating. To access it, you may need to remove some components or hoses for better visibility. Always ensure the engine is cool before attempting to locate or work on the valve.
the vacuum hose connects to the airbox
near the fire wall where the heater hoses enter
Check the vacuum operated valve at the hose going to the heater core.
No.
A 1993 Jeep does not have a transmission modulator valve.
It goes to the ac/heater control head.
No
Idle air control valve found on Tue backside of throttle body.
The transmission solenoids are inside the transmission on top of the valve body.