take grab handle cover off.remove screws.remove screws for door handle trim plate.remove screws on front of panel.remove screws on rear of panel(pop off screw covers and you will see screws).Pull out bottom of door panel.Gentle pry off tweeter up by mirror and disconn wire.Panel can come off enough so you can reach in and disconn window sw and door lite.remove panel.As best as you can peel off vapor sheet(its messy).Now you will see 2 blk plastic covers on sheet metal.pry them off.Disconn motor elec conn.Remove 3 nuts holding on motor.push motor to opening where you removed the larger plastic cover.You have enough room to turn motor and unscrew gear from old motor.Carefully pry gear away from motor.Put old mtr aside and attach gear to new motor.Push motor back up and reattch with the 3 nuts.Reconn elec conn.REvers procedure to reinstall door panel.Make sure all electrical conn are hooked back up.I did this on my 2003 tib and I believe 04 is same.
To remove the passenger door panel on a 2004 Hyundai Tiburon, start by disconnecting the negative battery terminal for safety. Next, remove any screws that are securing the panel, typically located in the armrest and behind plastic covers. Carefully pry off the panel using a flathead screwdriver or a panel removal tool, making sure to detach any electrical connectors for windows or locks. Finally, lift the panel upwards to free it from the door.
To replace the driver door window in a Hyundai Elantra, first, remove the interior door panel by unscrewing any visible screws and gently prying off clips. Once the panel is off, disconnect the window regulator and any wiring connected to the window motor. Carefully remove the broken glass and install the new window by guiding it into the regulator tracks, then reconnect the regulator and wiring. Finally, reattach the door panel and test the window operation.
To change the side mirror on a 2006 Hyundai Tiburon, first, remove the door panel by unscrewing the screws and carefully prying it off. Once the panel is removed, disconnect the wiring harness for the mirror if equipped with power adjustments. Then, unscrew the mirror from the door using a socket wrench, replace it with the new mirror, and secure it with screws. Finally, reconnect any wiring and reattach the door panel.
its in the panel on the left of the back seat behind the drivers side.
you need to pull the plastic off on the inside of the car to access it.
Flip open the cover and remove the two bolts securing the wiper arm. They are 12mm and 7/8 inch. Remove the inside hatch panel by removing four screws and working the panel loose. Unplug the wiring harness from the motor and remove it with a Philips head screwdriver. Replace the interior panel.
hammer PS use the right to
The fuel pump reset switch on a 2004 Hyundai Tiburon is typically located in the trunk, near the right side, behind an access panel. You may need to remove a cover or panel to reach it. This switch is designed to reset the fuel pump after a collision or if it has been triggered by a fuel system fault. Always refer to the owner’s manual for specific details related to your vehicle.
rear door panel ,how to open.
Push the door panel in around the window handle and use a screwdriver or a piece of wire with a hook to pull the clip off....it's in behind the handle.
A door panel on a 2005 Hyundai Accent is mounted with screws and clips. Loosen all the mounting screws. Pull the panel outward and pop out the clips. Remove the door panel.
Answerto remove the door handle you need to remove the door panel, which has 5 screws around it. One is under the handle you have to pry the cover off with a flat head (THERE IS A SLOT FOR THE FLAT HEAD) after that make sure your window is all the way UP NOT DOWN. there you should be able to see the 2 10mm bolts holding the handle bracket. You should be able to see the two metal rods push them until you can slip the plastic clips off and there you have a door handle from a 00 to 06 hyundai tiburon sitting in your hand