cant open tailgate
The fuse panel in a Pontiac Montana is located in the passenger door. It is located on the same level as the glove box.
to repair is just about useless, may as well replace it. to remove ..open plasticcap over the spindle nut and remove nut and washer, then open tailgate door and remove trim panel, disconnect wiring connector from wiper motor and remove mounting bolts, pull motor out and replace.
big hammer
To remove the tailgate panel on a GM Envoy, start by opening the tailgate and locating the screws or clips securing the panel. Use a screwdriver or trim removal tool to carefully detach these fasteners. Once they are removed, gently pry the panel away from the tailgate, taking care not to damage any clips or wiring attached to the panel. Finally, disconnect any electrical connectors if applicable, and the panel should come off easily.
To remove the back panel from a 1994 Toyota Previa tailgate, first, lower the tailgate and locate the screws around the perimeter of the panel. Remove these screws using a suitable screwdriver. Next, gently pry off the panel starting from one corner, being careful not to damage any clips or the panel itself. Once the clips are released, the panel should come off easily.
To remove the rear panel on the tailgate of a Lexus RX 330, start by opening the tailgate and locating the screws or clips securing the panel. Remove any screws using a screwdriver and carefully pry off the panel using a trim tool to avoid damaging the clips. Once the panel is loose, disconnect any electrical connectors if applicable, and gently lift the panel away from the tailgate. Make sure to handle it with care to prevent breakage.
By removing some screws and/or bolts.
To remove the interior panel from the liftgate of a Pontiac Montana, start by prying off any plastic covers or trim pieces that conceal screws. Use a screwdriver to remove the screws holding the panel in place. Carefully use a trim tool or flathead screwdriver to detach the panel from the clips around its edges. Once loose, gently pull the panel away to disconnect any electrical connectors and fully remove it.
To remove the electric back door panel on a 2005 Pontiac Montana Van, start by disconnecting the vehicle's battery to ensure safety. Use a flathead screwdriver to gently pry off any visible screw covers, then remove the screws securing the panel. Carefully pull the panel away from the door, starting at the edges, to release any clips holding it in place. Finally, disconnect any electrical connectors for the window or locks before fully removing the panel.
To remove the tailgate inner panel on a C4 Grand Picasso, start by opening the tailgate and carefully prying off any plastic covers or trim pieces to access the screws. Remove the screws securing the panel, then use a flat tool to gently detach the clips holding the panel in place. Once all fasteners are removed, pull the panel away from the tailgate, being cautious of any wiring connected to lights or sensors. Finally, disconnect any wiring harnesses before fully removing the panel.
To remove the tailgate motor from an '89 Ford Bronco, first, ensure the tailgate is fully closed. Disconnect the battery to prevent any electrical issues. Next, remove the interior panel from the tailgate by unscrewing or unclipping it, then locate the motor, which is typically secured with bolts. Finally, disconnect the wiring harness and unbolt the motor to remove it from the tailgate.
take the the black thing around it and then take it out dont worry it wont brake