http://ramchargercentral.com/index.php?PHPSESSID=0444fceb072ae517756147ef7ee51cd5&action=howtoshow;id=94
this page will show you exactly how enjoy http://ramchargercentral.com/index.php?PHPSESSID=0444fceb072ae517756147ef7ee51cd5&action=howtoshow;id=94
this page will show you exactly how enjoy
If You have Manual Locking Front Hubs, Then the 4 wheel drive will not work/drive the front 2 wheels at all without, Locking-Them-In . Do Not Lock and use the 4 wheel drive on Dry Pavement.
like you do in any other vehicle
Replace Remove starter Remove solenoid at top of starter Remove front end of starter for access Remove locking washer from starter shaft Drive should slide off shaft
The Ford locking hubs allow you to manually disconnect the front wheels of your vehicle from the front half shafts. This basically shuts the 4 wheel drive off.
The same way as a rear wheel drive.
With the 98 Durango safely lifted, remove the front wheel. Remove the locking hub. The hub removal is different depending on the hub type. Remove the brake caliper. Remove the axle nut, and slide off the bearing housing. The inner and outer bearings and races should be replaced.
remove wheels.remove brake calipers, remove 4x4 locking hub.with special socket remove axle locking nut. brake rotor will the slide off enabling you to change bearings
Remove the cover. Under the cover there is a C-clip. Remove it and the rest comes out.
there is no drive shaft it's front wheel drive
Remove the front drive shaft
Just pull it out. There should be nothing holding it in the differentail after you remove the locking hub and the hub.
you will have to remove your computers side wall (yes the whole thing) and unscrew it from the inside