If it is covered by carpet you may have to cut a "door" into it to get access to the light, some are pre cut. The whole bulb assembly is a white plastic framework holding all the bulbs. This has 3 or 4 clips protruding straight out that must be depressed inward towards the center simultaneously and the assembly will slide out. All the bulbs for that light are on that white plastic unit you have removed. Good luck.
how can i replace a brakelight bulb on a 2002 nissan frontier?
How to remove the sun visor on a 2002 VW passat driver side
The light assy has to be removed to take the bulbs out.
To replace the center brake light in a 2002 Ford Thunderbird, first, open the trunk and locate the plastic cover over the brake light assembly. Remove the cover by unscrewing any screws or unclipping it. Next, twist the bulb socket counterclockwise to release it, then pull out the old bulb and replace it with a new one. Reassemble the socket, replace the cover, and test the brake light to ensure it works properly.
how i found the change the oxygen sensor in 2002 vw passat
remove bulb from in side the boot
To replace the third brake light on a 2002 Mazda Protege, first, open the trunk and locate the plastic cover for the brake light assembly. Remove the screws or clips securing the cover, then gently pull it off. Disconnect the old light bulb by twisting it counterclockwise, replace it with a new bulb, and reassemble the cover by securing it back in place. Test the brake light to ensure it's functioning properly.
how do you replace brake-pads on vw beetle 2002?
Its a whole led unit replace whole deal not bulb
Take out the two screws and replace one or both of the lamps.
To replace the rear brake light on a 2002 Pontiac Bonneville, first, open the trunk and locate the tail light assembly. Remove the screws or clips securing the assembly and gently pull it out. Disconnect the electrical connector, then twist the bulb socket counterclockwise to remove it. Replace the old bulb with a new one, reassemble the components, and test the brake light to ensure it works properly.
Remove the wiring harness from the high mount brake light. Remove the retaining screws. Reverse the process to install the new high mount brake light.