WRONG
this answer is totally incorrect you can buy the bulbs they are not soldered you just have to remove the cluster and then take out the bulbs you need and take them to a gm dealership as they do not list them seperatly and have to match them with something on there shelves but you can get them seperatly dont fall for this
Both the "wrong" answer and the "right answer above are irrelevant to the question, because the shift indicator light for a 2002 Sunfire IS NOT IN THE DASH CLUSTER.
It's in the center console, where the the shift handle is.
To change the bulb is not too hard. And yes there is one there. First you need to pop out the square plastic piece where the power window buttons are. Next there are 4 bolts to take out to be able to lift the center console up. When you get the center console lifted up, you don't have to take the whole thing off, beside the shifter on the left side there are wires going up into a plastic box. You can turn it a little bit and the bulb will come down so you can replace it. It is a 194 bulb. Then you just put the bulb back, put the console back down and replace the bolts and you're done.
I have an 01 Pontiac sunfire and I have noticed that the check gages light comes on when the gas is low. I have never seen any other indicator come on for low fuel.
Read more: http://wiki.answers.com/How_do_you_replace_the_tail_light_in_a_2000_pontiac_sunfire#ixzz1Nur0XSlq
The indicator panel should by carefully pried out. Then you can change the bulb.
You must first remove the trunk door facia. (This is the part with the "Pontiac" lights in it.) Then you can get to the bulb to replace it.
Normally caused by faulty dimmer switch.
how do you replace shift indicator light escalade 2003
is the trac align light mean
To install a license plate light on a 1995 Pontiac Sunfire, first, locate the light assembly at the rear of the vehicle. Remove the screws or clips securing the light housing, then carefully pull it out. Replace the old bulb with a new one, ensuring it fits snugly, and reassemble the light housing by securing it back with screws or clips. Finally, test the light to ensure it functions properly.
What causes a 1997 Pontiac sunfire gt with a 2.4 liter engine to stall when stopped at a light
you should be able to buy the pigtail either at a parts store or the dealer. Otherwise you can get one from a junkyard fairly cheap and replace the bad one.
If you mean just the bulb, they are accessed from the trunk. Pull the carpet away from the back of the car and untwist the bulb holder. Replace the bulb and screw the holder back in.
I'm guessing that all of the light bulbs have been checked and are good. It's possible that you need to replace the flasher.