Key on, engine off. Press the gas pedal to the floor three times.
The service engine light can be reset on your Jeep Commander, by switching the message center to the oil life message. Once on the message, hold the check mark until it returns to 100%.
You can reset the oil light by scrolling to the oil life display. Once on the display, hold the scroll button in until the oil life goes to 100 percent
2010 patriots are chain driven. Therefore lasts the life of the engine. Unless an unusual problem accurs.
To reset the oil life on a 2011 Kia Sorento, first, turn the ignition to the "On" position without starting the engine. Then, press the "Gas Pedal" three times within 10 seconds. After that, turn the ignition off and restart the engine; the oil life indicator should now be reset.
To reset the oil life on a 2011 Ford F-250, turn the ignition to the "On" position without starting the engine. Press the accelerator pedal fully three times within 10 seconds. After that, turn off the ignition and then start the engine; the oil life should now be reset to 100%.
Turn key II position Press & hold Odomenter reset button until service light flashing. Press the reset button again for > 5 seconds The service oil life display will be reset to 100%
The life expectancy of a 2008 Jeep Patriot typically ranges from 150,000 to 200,000 miles, depending on factors like maintenance, driving conditions, and overall care. With regular servicing and good driving habits, some owners report their Patriots lasting even longer. However, like any vehicle, issues can arise that may affect longevity. Regular checks and timely repairs are essential for maximizing its lifespan.
Using the odometer post (little thingee sticking out of the speedometer) push the post until the oil life is displayed. Then push and hold the post for about 10 seconds. This should reset the oil life to 100%
Type your answer here... GO TO MENU, conveinece, oil life reset, hit ok when it reads set to 100 and hold ok!
To reset the oil change light on a 2011 Honda Accord, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within 5 seconds. The oil life indicator should reset to 100%. Turn the ignition off and then start the engine to confirm that the reset was successful.
To reset the maintenance light on a 2011 Acura MDX, first turn the ignition to the "ON" position without starting the engine. Then, press the "Select/Reset" knob on the dashboard until the oil life indicator appears. Press and hold the knob for about 10 seconds until the oil life resets to 100%. Finally, turn off the ignition to complete the process.
To reset, follow the instructions in the manual, but instead of the accessory position, turn the ignition to the ON position. Be very careful to not go past to the start position.