It is impossible to reset.
Press the "step" button until "0 miles to service" is displayed. Hold "reset" until it resets.
To reset the service performance light on a 2007 Jeep Commander, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within 10 seconds, then turn the ignition off. Restart the engine, and the service light should be reset. If the light remains on, it may indicate an ongoing issue that needs to be addressed.
To reset the "Perform Service" light on a 2007 Jeep Commander, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within ten seconds, then turn the ignition off. This should reset the service light. If the light remains on, you may need to check for any existing issues or consult the owner's manual for further instructions.
After fixing the cause of the code, you reset the code with a scan tool.
You need a code reader which plugs into port under dash. Any shop that has 1 can do for you or you can buy 1 at an auto parts store.
Move through the overhead display to where it says perform service. Hold down the Reset button for a few seconds and it will reset to "3,000 miles to service"
Time for an oil change.
Hit the step button until you see 0km to service the hold down the reset button.
Jeep Commander was created in 2006.
Jeep does not have reset switches.Jeep does not have reset switches.
To reset the oil light on a 2007 Jeep Commander, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within 10 seconds, then turn the ignition off. Start the engine to ensure the oil change light has been reset. If the light remains on, repeat the process.