if your message center is reading change oil turn the key to on position push gas peddle 3 times to floor turn key off and turn back on it should clear message center if its a check engine you need to fix the problem it wont fix itself
How do turn off low tire pressure light in my message center??
to reset the oil change lite turn the key in the ignition to the on posicion right before cranking it. then press and release the the gas pedal compleatlly three time with in five secounds. the message center should blink.if not try again this time press the gas pedal four times.
on a 2001 silverado you clear the message center by turn the ignition to the on position and pressing the gas pedel all the way to the floor 5 times in 5 seconds
There should be a switch for that in the center console.
turn key to on 'NOT STARTING ENGINE' press gas pedal to floor 3 times within 5 seconds will reset oil change message
To change the language on the message center of a 2004 Mercury Monterey, turn on the vehicle and locate the "Menu" button on the message center controls. Press the "Menu" button until you see the language option displayed. Use the arrow buttons to navigate to your preferred language, then select it by pressing the "OK" or "Select" button. The message center should now display messages in the chosen language.
Whats the message. different messages have different ways of clearing. for example if its the change oil message. you turn the ignition to ON but do not start the car pump the gas pedal 3 times fast then turn the car off. then start it. Or you can use the factory radio to settings.
there are two center stage movies. one aired last year 2000 and the other on 2008, the turn it up edition...
You turn the headlight switch to the left when you start the vehicle.
I don't know if this will work for non-turbo models or other years of the S80, but it worked on my car: 1. Insert ignition key and turn to position I. 2. Push in the odometer reset stalk and hold it in. 3. Turn the ignition key to position II. Continue to hold the odometer reset stalk in. After a few seconds the Service light will begin to flash. 4. Release the odometer reset button. 5. Turn the ignition off. You're done!
The turn signal flasher on a 2008 Chevy Avalanche is located inside a panel close to the gas pedal.
1.Press and release the trip/reset button until the OIL LIFE message is displayed. 2.Press and hold the trip/reset button until a chime sounds five times and RESET is displayed in the message center. When the system is reset, the odometer will again be displayed in the message center. 3.Turn the key OFF. If the CHG OIL message cames back on when you start the vehicle, the system has not reset. Repeat the procedure.