There should be a switch for that in the center console.
Automatic Stability Control (BMW)
The standard 2001 BMW z3 Coupe does not have a switch to turn off the airbags. However, you can have this switch installed by the dealer as an upgrade.
Push the button.
To reset the oil life monitor in a 2000 BMW Z3, turn the ignition key to the "On" position without starting the engine. Press the gas pedal fully three times within five seconds. After doing this, the oil life monitor should reset to 100%. Finally, turn the ignition off and then back on to confirm that the reset was successful.
Take off the old one and put the new one on.
To manually reset the service engine soon light on a 2000 BMW Z3, you can use the following steps: First, turn the ignition key to the "On" position without starting the engine. Then, press the gas pedal fully three times within five seconds. Finally, turn the ignition off, and the light should be reset when you start the vehicle again. If the light stays on, there may be an underlying issue that needs to be addressed.
most likely 91
The lights on a BMW Z3 operate through a combination of switches and relays that control various lighting functions, including headlights, taillights, and turn signals. The main headlight switch, typically located on the dashboard, allows the driver to turn the lights on and off and control the brightness of the dashboard lights. The car uses halogen bulbs for the headlights, which provide bright illumination, while the taillights and turn signals use standard bulbs. Additionally, the Z3 features an automatic light system that can turn on the headlights in low-light conditions.
Yes, at least when they left the factory.
My 1998 BMW Z3 is having the same problem and now the ignition seems to be locked and the key won't turn. The car died when I let the clutch out. The car now seems to be stuck in aux. mode. The key is out but the dash lights remain on and you can use all of the electronic options. Did you ever figure out what was wrong?
Codes can only be cleared by the use of diagnostic equipment.
z3