answersLogoWhite

0

It'll have too much play in it. Everything should be tight.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you repair ball joints on 96 grand marquis?

Remove the tire and wheel from your 1996 Mercury Grand Marquis. Remove the ball joint retaining nuts. Pound the ball joint out with a hammer. Reverse the process to install your new ball joint.


What are the symptom of an automobile universal joint going bad?

A clunking sound when you accelerate or decelerate.


Why does the rear drive system start to vibrate after you take off in a 1993 Mercury Grand Marquis?

There are a few possibilities that i would check out. For example: You can have a bad belt in one of the rear tires. Or a rear wheel bearing could be bad. Or a carrier bearing may be bad. Please check and make certain that the lug nuts are tight. A pinion bearing gone bad is a slim but possible option. However, the first thing i would check would be the rear universal joint. If the universal joint is seized or the needle bearings in the universal joint are bad it would certainly cause the vibration that you are describing.


2000 silverado universal joint keeps going out is this a rear differential problem?

No, The joint is just not being put in correct. Go buy a good u-joint SORRY


What causes your 95 ford aerostar to vibrate while driving?

A universal joint on the driveshaft going bad.


What causes a noise at the end of a gearbox on a alfa spider 1982?

Could be a universal joint going bad.


What do you put universal joints in?

a universal joint holder.


How can you tell the front bearings are going out on a 2000 grand am?

"clicking" when taking turns -- indicates CV joint is going bad


Who invented the universal joint?

The first universal joint was created by Londoner Robert Hooke, a scientist of the 17th century.


Is universal joint a lower pair joint?

Yes, a universal joint is a type of lower pair joint that allows for rotational motion between two shafts that are not in line with each other.


When do universal joints need to be changed?

when the joint becomes worn, you can tell when it is warn as it will vibrate and a clunk sound will be heard when going in to gear.


What is the Clicking nosy you hear under toward the rear of a 1998 S-10 Pickup 2.2 Manual?

Universal Joint going bad?