The 2001 Pontiac Montana block heater cable can be found in the front of the vehicle. You can access the block heater cable through the front grill.
Begin by removing the positive cable from your battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new Pontiac Montana battery.
There is no speedo cable on a Sunfire.
replace the shift cable
If it is broken they cannot be repaired. You need to replace it.
if both the inside and outside door handles work then the cable that opens the door automaticlyis jamed in the moter. Replace the auto open moter or like I did cut the cable and use the door manuly.the cable and auto moter is located under the trim on the passenger side in the rear hatch area
To replace the water pump on a 2006 Pontiac Montana, first, disconnect the negative battery cable and drain the coolant from the radiator. Remove components obstructing access to the water pump, such as the serpentine belt, engine cover, and possibly the alternator. Unbolt the old water pump, clean the mounting surface, and install the new pump with a new gasket. Finally, reassemble the components, refill the coolant, and check for leaks.
Honda Odyssey sliding door cable repair
To remove the wiper switch on a 2000 Pontiac Montana, first disconnect the negative battery cable to ensure safety. Then, remove the steering column cover by unscrewing any screws and gently prying it apart. Disconnect the electrical connector from the wiper switch and remove any screws securing the switch to the column. Finally, pull the wiper switch out and replace it as needed.
no, you should be able to replace it with out disassembling the whole starter....
where can i attach the negative of my cable to jumpstart my battery for 1997 Montana van. Attach the negative cable to any bare metal within the engine itself, be sure to keep the cable clear of any belts or moving parts. There is a bolt in the middle of the engine that I used last week to perform the task.
To reset the computer on a 2001 Pontiac Montana Van, you can disconnect the negative battery cable for about 15 minutes to clear any stored error codes. After reconnecting the cable, turn the ignition to the "On" position without starting the engine for a few seconds. This allows the computer to reset. Finally, start the van and let it idle for a few minutes to allow the system to recalibrate.