To reset the computer on a 2001 Pontiac Montana Van, you can disconnect the negative battery cable for about 15 minutes to clear any stored error codes. After reconnecting the cable, turn the ignition to the "On" position without starting the engine for a few seconds. This allows the computer to reset. Finally, start the van and let it idle for a few minutes to allow the system to recalibrate.
2001 Pontiac Montana?
how i can reset the security sistem for a Pontiac 2001 grand am
How much refrigerant is needed recharge ac on a 2001 Pontiac montana
to reset the computor..all you have to do is take the negative battery cable off for about 10 min. then tighten back on. tada!
I am still waiting for the answer u cant reset the abs light u have to take it to the shop, if your abs light is on there is something wrong with your trac system
2001 Montana has an electronic transaxle. There is no vacuum modulator. The 2001 Montana has an electronically controlled transaxle. There is no vacuum modulator.
yes it has one
No
To reset the "Service Engine Soon" light in a 2001 Pontiac Montana, you can use an OBD-II scanner to clear the diagnostic trouble codes. Alternatively, you can disconnect the negative battery terminal for about 15 minutes, then reconnect it. This may reset the light, but ensure that any underlying issues are addressed to prevent it from coming back on. Always consult your vehicle’s manual for specific instructions related to your model.
under the antifreeze compartment
The 2001 Pontiac Montana block heater cable can be found in the front of the vehicle. You can access the block heater cable through the front grill.
There is only one fuel pump fuse on a 2001 Pontiac Montana. It can be found in the engine compartment near the firewall at the rear of the compartment.