Your Brake light is a warning light, it means something is wrong with your brakes, first you should check your pads for wear (if you feel a grinding sound every time you press the brakes they are shot), sometimes brake pads have wear indicators (a wire that when the pad wears surfaces closing a circuit and turning the light on), another possibility is low brake fluid level. Another yet is that one of the circuits has failed (there are two), If all these checks do not give you an answer, take it to a specialized brake shop, you don´t want to suffer the failure of your brakes when least expected, NEVER save mone on brakes, they are the most important system in your car.
Replace the bulb it works when you turn on the driving lights and when you brake. there are two little springs inside the light one is for the brake light and the other is for the driving light. All you need to do is replace the bulb. good luck.
First check your turn signal switch
The 1996 Chevrolet Camaro parking brake has an adjustment bolt on the parking brake. Turn the adjustment bolt to adjust the brake.
The red brake light indicates that the parking brake is on or that the brake fluid is low. Be sure to add the specified brake fluid if you add fluid. Also make sure that you don't allow any dirt to get into the brake fluid and don't overfill the brake fluid either.
mine is a button on middle council, by emergency brake. says ect
No , the rear brake lights do not turn on when you use your parking brake , just the brake light on your dash is supposed to come on
Check bulbs - double filamented with smaller being for brake light and turn signal Bad switch? Bad turn signal flasher?
Yes. I have found the schematic in the back of most "Haynes" manuals.
It is possible the brake light switch is broken or out of adjustment and the lights you see in back are the brake lights stuck on.
In many cases, the brake light and the turn signal use the same bulb.
If it is a single bulb, it is probably the bulb. Many tail light bulbs have two separate filaments, with the turn/brake being much brighter than the marker light. The tail light and turn/brake circuits are completely separate.
Brake light, on your 2000 Chrysler Concorde, by accessing it from the inside of the trunk. Take hold of the brake light, push in and turn. The brake light will come out.