0
First, disconnect the negative battery cable. Raise and support the vehicle. disconnect and cap the hydraulic line at the slave cylinder. Remove the slave cylinder. To install, reverse procedure. After you are finished Bleed the system.
To bleed system:
Fill reservoir with clean DOT3 brake fluid. Have a friend depress the clutch pedal to pump up the system. While your friend holds the clutch pedal to the floor open the bleeder screw. Close the bleeder screw and release pedal. Repeat this process until no air comes out of the bleeder screw. Make sure the master cylinder reservoir stays full during the process or you'll be starting it over again.
What else can I help you with?
How do you change a clutch slave cylinder on a 1988 Chevy S10 Pickup?
You will need to remove the transmission to replace the clutch slave.
How do you connect the hydraulic to the clutch slave cylinder on a 2000 S10 chev pickup 2.2 4 cylinder?
how do you connect the hyraulic master cylinder to the clutch slave cylinder on a 2000 chevy S10 pickup 2.2 4.cylinder
Where is the slave cylinder on a 94 Chevy S-10 pickup?
The slave cylinder is actually built onto the throw-out bearing. If you have a problem with it you will have to pull the trans.
Do you have to pull the transmission to change the slave cylinder on a 1988 Chevy pickup manual transmission 4.3 v6?
No. It unbolts from the transmission just under the starter. The hardest part will be unhooking the line from the cylinder. Use a nail and a pair of pliers to push the roll pin out.
Your clutch fluid is leaking near the passenger side of the trans on your 1989 Chevy pickup what could it be?
Perhaps slave cylinder, line or fitting leaking?
How do you adjust the slave cylinder on a 1989 Chevy pickup 1500?
There is NO adjustment, You must replace the clutch set to bring the pedal back to the right position. You also need to make sure the clutch slave cylinder/ master cylinder is good before replacing clutch assy.
How do you adjust clutch on a 1983 k20 Chevy pickup?
There is NO adjustment. It is adjusted automatically through the hydraulic slave cylinder. Probley time for a NEW clutch kit.
Where is the clutch slave cylinder on a 1994 pickup truck?
The clutch slave cylinder , for a hydraulic clutch , is inside the manual transmission bellhousing
How do you replace the slave cylinder in 96 Chevy C1500?
How do you replace a slave cylinder in a 96 chevey k1500
How do you change hydraulic clutch in 99 Chevy s10?
Which part do you want to replace? The slave cylider or the master cylinder? The hydraulic line and master cylinder.
Where is the slave cylinder on your 1982 Toyota pickup?
on the passenger side of the transmission
How and where do you change a slave cylinder for a 1993 Chevy S10 manual pick up?
The slave cylinder on my s10 in on the driver side of the transmision. There are only 2 nuts that have to be removed to take the slave cylinder off. Then u must take out the pins to remove the clutch line.. Hope this helps
