on the passenger side of the transmission
If the clutch is hydraulic, yes. If the linkage is mechanical, no.
It should be on the cylinder head where the top hose attaches.
Slave cylinderTry autozone.com, they have a free repair guide online. I've used it many times on a 93 Toyota and it does have information back to 1982. heck, it even has overhaul procedures. they call the slave a "release" cylinder. hope this helps, and good luck with your yota.
Junkyard!
how to change filter
Uder the dash near the steering colmn. It looks like a flasher.
The width of a 1982 Toyota pickup box, also known as the bed, is approximately 57.5 inches (about 146 cm) between the inner sides of the wheel wells. The overall width of the truck bed can be around 65 inches (approximately 165 cm) at the top edges. Keep in mind that these dimensions can vary slightly depending on modifications and specific model variations.
On the side of the transmission underneath the vehicle. This requires a pump to add trans lube.
Look under the front end of the vehicle. Look at the front suspension components. Locate the tie rods and center link. There should be a slve cylinder (hydraulic cylinder) attached; one end to the center link and the other end to the frame. Example car that used the slave cylinder system: Corvette 1963 thru 1982.
Try the Haynes Repair Manual for Toyota Pickups and 4Runner '79 thru '95. This is available at most auto parts stores such as Autozone or O'Rielly's.
1982 Toyota pin-out connections to alternator?
1982-1993 Chevrolet&GMC S10&S15 pick-ups (Hayens Repair Manual).