0
What else can I help you with?
Where is the slave cylinder on your 1982 Toyota pickup?
on the passenger side of the transmission
How do you connect the hydraulic to the clutch slave cylinder on a 2000 S10 chev pickup 2.2 4 cylinder?
how do you connect the hyraulic master cylinder to the clutch slave cylinder on a 2000 chevy S10 pickup 2.2 4.cylinder
Where is the clutch slave cylinder on a 1994 pickup truck?
The clutch slave cylinder , for a hydraulic clutch , is inside the manual transmission bellhousing
Where is the slave cylinder on a 94 Chevy S-10 pickup?
The slave cylinder is actually built onto the throw-out bearing. If you have a problem with it you will have to pull the trans.
How do you change a clutch slave cylinder on a 1988 Chevy S10 Pickup?
You will need to remove the transmission to replace the clutch slave.
Does a d21 Nissan pickup 4x4 have a different slave cylinder than a 720 pickup?
I went to autozone.com and looked both up and they are different.
How do you replace slave cylinder Mazda B3 pickup?
To replace the slave cylinder on a Mazda B3 pickup, first, ensure the vehicle is safely elevated and secured. Remove the transmission's access cover and disconnect the hydraulic line from the slave cylinder, followed by unbolting the cylinder from its mounting. Install the new slave cylinder by securing it in place, reconnecting the hydraulic line, and then bleeding the clutch system to remove any air. Finally, recheck for leaks and ensure proper clutch operation before lowering the vehicle.
Trying to find the thermostat on 1982 Toyota pickup?
It should be on the cylinder head where the top hose attaches.
Where is the clutch bleeder valve on a 1983 Nissan 720 pickup?
It should be down below where the slave cylinder connects to the tranny
Why does your 1985 Nissan Pickup Truck cut off or bog down when you put it into gear?
check clutch slave cylinder
How do you adjust the slave cylinder on a 1989 Chevy pickup 1500?
There is NO adjustment, You must replace the clutch set to bring the pedal back to the right position. You also need to make sure the clutch slave cylinder/ master cylinder is good before replacing clutch assy.
How do you replace a clutch slave cylinder on a 1982 Toyota truck?
Slave cylinderTry autozone.com, they have a free repair guide online. I've used it many times on a 93 Toyota and it does have information back to 1982. heck, it even has overhaul procedures. they call the slave a "release" cylinder. hope this helps, and good luck with your yota.
