Try checking the housing of the bulb b/c you may have water entering which is causing it to burn out the bulb. Also check to see if your wiring is good, check the resistance on the negative and positive cable w/a Digital Multi Meter. One last thing check the socket b/c if the socket is burned that's what's causing not to fuction also. Hope this helps out let me know what happened
If it is the front turn signal bulbs that are acting up (not flashing just turning off when you turn on your signal) it can also be your forward lights control module. Its a small box about the size of a deck of cards behind your radio. It will have two wire harness going to it. Mine went bad and caused me a turn signal problem.
Had a similar problem on my daughter's car. Water had gotten into the sockets. I took some 100grit sandpaper, scuffed them up inside nice and clean, replaced the bulb(s) and all was well.
If one turn signal is flashing fast it is to warn the driver they need to replaced either the front or back signal bulb.
get the bulb replaced in the light of the side that's blinks too fast
If the blinker is not working on a Mazda 121, check the turn signal flasher. If the bulb needs to be replaced, remove the lens cover and insert a new bulb.
You fix it cause its broke.... Check the left bulb
May sure the housing is good and not Corroded. If it is Corroded you may need to replace it.
To fix a turn signal on a Nissan Frontier, first, check the turn signal bulb to see if it's burned out; if so, replace it with a new bulb. If the bulb is fine, inspect the turn signal fuse in the fuse box for any damage and replace it if necessary. Additionally, check the turn signal relay and wiring for any faults. If these steps don't solve the issue, consider consulting a mechanic for further diagnosis.
bad or wrong bulb is your lights
bad bulb, relay, wiring, turn signal switch
f150 turn direction bulb needs to be changed. How do i get to it? My Right Directional signal is clicking fastert than normal ?? all the lights (bulb's) seem ok ??
The trun signal lever needs to be replaced.
Check the bulb and the flasher. Check the bulb and the flasher.
This is because the tail light bulb has a different element in the bulb. Just replace the bulb and that will fix the problem.