0
Is an ignition module for the 1981 Dodge Ram Camper van a rare part to find for that year's model?
Wiki User
∙ 17y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you change the ignition control module on 1996 mercury cougar xr7?
there is no ignition control module on the 1996 model its all through the PCM
What is the gap for ignition module weedwacker model 358.796280craftsman part530039211?
You can set the gap on the ignition module if the flywheel's magnets are not close. The gap should be at least 0.010 to 0.012 from the flywheel.
Where is fuel filter on dodge magnum rt?
The late model Dodge Magnum (2005+) fuel filter is in the tank, part of the pump module.The late model Dodge Magnum (2005+) fuel filter is in the tank, part of the pump module.
How to replace the ignition module in a 1999 Ford Contour?
What engine? Ford contour 2.0L DOHC eng. distributorless ignition are controlled by the main PCM There is an ignition module on the 99 contour 2.0 with automatic transmission. It is shown in the schematics for this model.
Where is the Location of ignition module on chevy 1500 pick up5.7 liter2 wheel drive LS model?
The ignition module on a 5.7 Chevy engine should be on top of the motor. It is mounted beside the distributor.
Where is the ignition module located on a 1994 dodge ram 1500 5.9?
The 60-pin ignition module should be mounted in the engine bay on the firewall or fender (varies by year/model.) Find more information here: (or use the 'related link', below.): http://www.autozone.com/addVehicleId,1941203/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c152800706c8 Good luck.
Where is the ignition control module on a 1997 Sonata?
Regarding a model 1997,2 liter sonata, there is not an ignition control module as such. Ignition control comes from the ECM (ELECTRONIC CONTROL UNIT) through the Ignition Power Transistor (often called Igniter) and then to the Ignition coil.I do not have any information on the 1.8 or the 3.0 liter models.
Where is the ignition module on a 1997 Ford Contour?
AnswerThe ignition module is mounted to the front of the distributor. It is a long rectangular piece (about 1"x4") with wires connected to one side. Yes the Ignition module is rectangular piece (about 1"x4) with wire harness connected to it, but some Ford Contour does not have distributor, they have coil park, and some of this car have their ignition module built in the PCM. Year, Make, Model, and Engine size makes a different.
Do you have to go through the steering column to replace an ignition module?
Are you talking about the electronic ignition module or the ignition switch? The ignition module sits in the engine compartment and is part of the ignition system (coil, spark plugs, etc). The answer is no if this about what you're referring. The answer for the ignition switch will depend on the vehicle you have. Some, like late model Fords, you don't. Push in the retaining pin and the ignition switch comes right out (you still need a key though). Others you need to take off the steering wheel to replace the switch.
Where is ignition control module and what does it look like in Ford Festiva 1990 fuel injection model?
i know on a wb its in distributor
Why when your car warms up you loose spark?
Without year make model & engine size you get a guess. Ignition module, coil, distributor
How do you test the control modules on a 1986 Ford Escort?
If by control module you are referring to an ignition module then you need to remove it from the distributor and take it in to a shop for testing ,it requires special equipment for testing.A new module runs from $50-$100 depending on model
