The bolt pattern for the door hinges on a 1988-1994 Chevrolet Cavalier is generally not the same as that of a Chevy Beretta, as these two models have different designs and specifications. While they may share some components due to being from the same manufacturer, it is advisable to verify compatibility through specific part numbers or by consulting a repair manual. Always check with a reliable source or mechanic for precise information regarding interchangeability.
I would try Rock Auto.
Buy a new hinge from the dealership it should cost about 20 - 25 dollars. you will get the upper and lower hinge for either the driver or passenger door. there are only four bolts holding each hinge on . use a marker to mark where the old hinge was then take off the old one. you can do this with the door being ajar but i am told that it is easier with the front fender off. it will probablly take two people to do this. I would also suggest that you purchase the haynes manual for the car they are very useful.
to the left of the steering column, near the door hinge
dealer parts department?
A little grease.
To replace the fuel door hinge on a 2005 Chevy Malibu, first, open the fuel door and locate the hinge. Remove the old hinge by unscrewing any screws or bolts that secure it to the body. Align the new hinge in place, then secure it with the screws or bolts. Finally, test the fuel door to ensure it opens and closes properly.
Replace the hinge pins and bushings.
Open your doors, you may need to remove your fenders .Then find the nuts for the hinges, remove the nuts while supporting the door. Be careful of your door. Remove the hinges from the frame, replace, follow through in reverse.
I need passenger door hinges for my chevy aveo 2007
I would recommend you replace the entire hinge and forget about repairing it. In my experience this is the best route to take.
Not removable- replace entire hinge assembly
i used to work for a Chevy dealer....if you already put new hinge pins and bushings in you now have to replace hinges that have to be welded in