96 contour has an electric fan, so no fan belt
I'm not sure which engine you have, but, the 2.0 has the camshaft sensor on the drivers side of the engine, right in front of the distributer
In the drivers footwell , on the side panel in front of the drivers door , there is an access hole for the switch
The coolant fan switch on a 1998 Contour is located at the front of the engine, near the radiator. It controls the speed and operation of the cooling fan based on the actual engine temperature.
On a GM engine The #1 cylinder is located drivers side, front of engine.
The heat shield on the engine is located on the front of the engine over the exhaust manifold. It is on top of the engine just behind the radiator.
it is located to the front of the engine on the drivers side..
the low side service port is located behind the drivers headlight, in front of the airbox.
Since you are asking, I assume you have a V6 Duratec powered contour. If this is the case, the IMRC is located just in front of the engine, underneath the IMRC cover, the plastic cover mounted to the engine with several screws and says "Duratec" on it.
It is located near the front drivers side of the engine.
This is not the Ford Contour page this is the Escort Page. ========================================================= On a 1998 Ford Contour : The fuel pump shut off switch ( inertia switch ) is located in the drivers footwell behind the kick panel ( there is an access hole ) * the kick panel is the interior trim panel , in front of the front door , beside the drivers left foot
I believe it is on the drivers side of the engine , near the front of the engine
The Ford Contour/Mercury Mystique is a front-wheel drive, transverse engine car. In other words, the engine is mounted "sideways" in the front of the car, and drives the front, rather than the rear wheels. The transmission (or, more properly, the "transaxle") is bolted to the engine on the left side of the engine compartment. It contains the transmission itself, along with the differential.