0
What else can I help you with?
Where is the knock sensor on a 1997 thaoe?
location of knock sensor in 1997 cheverolet Tahoe SUV 305 or 350 engine
Can a k Oil sensor leak oil?
can a knock sensor leak oil for 305
What sensor is located on the passanger side of the engine block near the starter on a 86 Chevy 305?
That is the knock sensor.
What is the sensor on a 305 Chevy motor right next to the starter?
it is a knock sensor that is used to adjust the ignition timing.
What does a knock sensor for a 1991 Chevrolet Camaro 305 look like?
the knock sensor on a 91 camaro 305 in on the passenger side of the block, bellow the exhaust manifold. its a few inches in front of the bell housing., and has a single wire running to it. looks a bit like a temp sensor, or oil pressure sensor.
How many wires are connected to the knock sensor in a 82 Chevy k10 305?
1 wire.
Where knock sensor Pontiac firebird 1986 v8 305 ci?
The knock sensor on a 1986 Pontiac Firebird with a V8 305 CI engine is typically located on the engine block, near the oil filter or on the side of the engine. It is usually positioned to detect vibrations caused by engine knock or pre-ignition. To access it, you may need to remove some components, as it can be somewhat hidden. Always refer to a service manual for specific details on your vehicle's layout.
What is the difference between a Chevrolet 305 and the Chevrolet 305 HO?
Different pistons, bigger valves, different cam.
Could a anti knock sensor that is unplugged or defective cause problems with the 305 motor starting?
No, a faulty knock sensor will cause a code 43 normally. check for spark, diconnect a wire from a plug, install a plug in the wire, lay it on something metal, have an assistant crank the motor and watch for spark...
Where the knock senor located on a 87 Chevy custom van 305?
it is on the drivers side of engine block screwed into block near side freeze plugs it is a 2 inch round sensor with a wire on top center of sensor
How do i remove the knock sensor on a 305?
Drain cooling system. Carefully disconnect wire to sensor and use wrench (7/8 I believe) to carefully remove old and install new, reconnect wire. Alse make sure threads of new sensor have sealant on them
Knock sensor on a 1994 305?
It is screewed into the engine block over by the starter, When you remove it antifreeze will run all over the place so be fast about it and make sure engine is cold.
