Drain cooling system. Carefully disconnect wire to sensor and use wrench (7/8 I believe) to carefully remove old and install new, reconnect wire. Alse make sure threads of new sensor have sealant on them
location of knock sensor in 1997 cheverolet Tahoe SUV 305 or 350 engine
yes
can a knock sensor leak oil for 305
That is the knock sensor.
it is a knock sensor that is used to adjust the ignition timing.
where is the knock sensor located on 93 cutlass ciera
the knock sensor on a 91 camaro 305 in on the passenger side of the block, bellow the exhaust manifold. its a few inches in front of the bell housing., and has a single wire running to it. looks a bit like a temp sensor, or oil pressure sensor.
1 wire.
One Sensor.... Removal Procedure 1. Remove the intake manifold. 2. Disconnect the knock sensor electrical connector. 3. Remove the knock sensor. Installation Procedure 1. Install the knock sensor. Tighten the knock sensor to 19 Nm (14 lb ft). 2. Connect the knock sensor electrical connector. 3. Reinstall the intake manifold.
It is screewed into the engine block over by the starter, When you remove it antifreeze will run all over the place so be fast about it and make sure engine is cold.
how you can remove the knock sensor from a 1996 Nissan pathfinder i need a picture
There are 2 knock sensor under the intake manifold, You will need to remove the intake to get to them.