DRL module
it is mounted on the starter.
power or manual?
WWW.Berettastuff.Com they will answer any question you have about codes.
In a 1996 Chevrolet Beretta, the emergency fuel cut-off switch is typically located in the trunk area, near the fuel tank. It is often a small, red button that can be reset after an accident or impact. If you need to access it, check the owner's manual for specific guidance on its exact location and operation.
There is a sensor in the side of the radiator that is most likely defective.
Its a front wheel drive coupe produced by Chevrolet. More specifically' it was produced by their division of General Motors in the 1987-1996 model design.
The 3.1 litre V6 engine in a 1996 Chevrolet Beretta has a timing CHAIN
To fix the door handle and lock on a 1996 Chevrolet Beretta, start by removing the door panel using a screwdriver to take out screws and clips. Once the panel is off, locate the handle and lock mechanism, checking for any broken components or misalignments. Replace any damaged parts and ensure the linkage is properly connected. After making repairs, reattach the door panel securely and test the handle and lock operation.
There is a sensor either in the coolant recovery jug or the radiator side tank that is defective.
The horn is located in the right front corner of the fender of the car. You will have to remove the air deflecting panel just in front of the right front wheel to access it.
you have to take ther screws out of the dash and take the dash off and you should be able to reach them easly you have to take ther screws out of the dash and take the dash off and you should be able to reach them easly