antifreeze coming from back of
intake on 1993 gmc sierra
No, it's a switch that has to be replaced (common part on a lot of cars). Some cars have more than one so you must specify which sensor you need at the parts supply place.
You need to get the temperature sensor repaired or, more likely, replaced.
There is more than one O2 sensor in that vehicle and they are all threaded into the exhaust system at various points.
Thermocouples RTD Pyrometers Scanners It depend on the application for which temperature sensor be used, for more detail... go to link http://tempsensindia.com/temperature_sensor_article.htm Thanks Vijay
Location of coolant temperature sensor on a 2003 Mercury Grand Marquis?Read more: Location_of_coolant_temperature_sensor_on_a_2003_Mercury_Grand_Marquis
IAT sensor (intake air temperature) or more commonly known as the MAT (manifold air temperature) sensor is located on either the air intake snorkel or the manifold
a temperature semsor is more accurate at measuring things like body heat
The air intake temperature sensor is part of the mass air flow sensor. This is generally located behind the air cleaner. Refer to the Service Manual for more details.
Depends on which relay you are looking for, there are many. Re-post question with more info.
On the 2000 town car, the ambient temperature sensor is under the hood. More precisely, behind the grill mounted to the upper radiator support.
a temperature sensor could be faulty...i have a 1994 legacy and i had the same problem...i replaced the temperature gage sensor and i have no more problems.
the coolant temp sensor( cts) reads the temp of the engine and adjust the fuel air mixture depending on the temp. if its cold out the sensor will adjust for more fuel to ease the start of the engine. ADDITIONAL: The Coolant Temperature Sensor measures the temp of the coolant, not the engine. The sensor controls the thermo fans on/off. depending upon temperature. The actual engine temperature sensor is on top of the engine and does not control the fans. If the fans do not switch on at any temperature, disconnect the 2 wire connector from the sensor (Usually at the bottom of the radiator) If fans start up with connector disconnected, replace the sensor.