which one?
The valve is on the passenger side of the car follow the lower radiator hose back to the thermostat housing and it be top
open bleeder valve on slave cylinder,gravity is going down hill,so get aclear hose and put on bleeder valve and openand pump clutch pedal until air is gone,dont let fluid get to low.
The location of the BCM on a '97 Cavalier can vary based on the model. Many of them are just left of the hedge pillar and below the instrument panel. Some are above the instrument panel.
there is not one. You must turn the heater on and take radiator cap off. Of course car must be running.
The brakes on a 97 S-10 are bled by attaching a vacuum pump to the bleeder valves and loosening the valve. The vacuum is then used to draw out air until only fluid is present.
the Hyundai rear caliper needs to be twisted(clockwise) to compress the piston. Dont try to pry it or vice it . Remove bleeder valve if it still doesnt retract, then bleed entire system. Fresh fluid is always good for the seals and the muck youll see coming out of the bleeder valve is proof of why its giving you trouble.
On a 1997 Honda Civic CX, the coolant bleeder valve is located on the engine block, specifically on the thermostat housing. To access it, you'll need to look near the upper radiator hose connection. The valve is a small screw or bolt that can be opened to release trapped air from the cooling system during a coolant change. Be sure to do this when the engine is cool to avoid burns.
how do you remove and replace the distributor cap on a 97 chevy cavalier?. I can not get to it.
Location of horn on 97 Chevy cavalierit is inside the front right bumper by the marker light
how do i remove the upper intake manifold on a 97 chevy cavalier 2.2l v4
no headlights different
Yes