0
If you have your stomach touching the front of the car. the blower is located on the lefthand side closest to the cab. Its behind a rubber insulator and an absolute pain to replace. I have a 1997 Bravada and it took more time to remove the computer and cut the rubber out than it took to replace the blower. I would not recommend this as a do it yourself. I would still be under the hood trying to figure it out. The blower is cheap. $40 or so. the labor to get it replaced is another story.
What else can I help you with?
How do you change blower motor on a 93 gmc sierra 1500?
Remove the wiring harness from the back of the blower motor in your 1993 GMC 1500. Remove the blower motor retaining bolts. If the new blower motor does not have the fan attached to and you will need to remove the fan from the old blower motor. Reverse the process to install the new blower motor.
How do you replace blower motor for a 2006 Chevrolet coloardo?
To replace a blower motor in a 2006 Chevrolet Colorado first remove the old blower motor. Then install the new motor making sure to connect all the wires.
How do you replace the blower motor on 01 Chevy Malibu?
remove panel under glove box. slide bcm to one side. ( it is much easier if glove box is removed ). remove 3 screws from blower housing. pull the blower motor and fan straight down. disconnect the blower motor electrical connection, if you are replacing blower motor with a new one, use old blower fan from old one.
How do you install 94 suburban heater blower motor?
To install the heater blower motor in a 1994 Chevrolet Suburban, first disconnect the negative battery cable for safety. Remove the blower motor cover and disconnect the wiring harness from the old motor. Unscrew the old blower motor from its mounting and replace it with the new one, securing it in place. Finally, reconnect the wiring harness, replace the cover, and reconnect the battery cable.
How do you replace blower motor 1998 Oldsmobile intrigue?
To replace the blower motor in a 1998 Oldsmobile Intrigue, first disconnect the negative battery cable to ensure safety. Then, remove the passenger side lower dash panel and the blower motor cover. Disconnect the electrical connector from the old blower motor, unscrew it from its housing, and then install the new blower motor by reversing the process. Finally, reattach the dash panel and reconnect the battery.
You replaced the blower motor on 97 Mercury Tracer and it still doesn't come on What should you try next?
Was the blower motor defective, or where you just guessing. Did you apply 12 volts to the old motor to see if it was bad? Did you check the Fuse. It may be a defective blower motor resistor pack which is a common problem on this car.
How do you change a front blower motor on a 2001 Mercury Villager?
To change the front blower motor on a 2001 Mercury Villager, first disconnect the vehicle's battery to ensure safety. Remove the passenger side lower dash panel and the blower motor cover. Disconnect the electrical connector and unscrew the old blower motor from its housing. Install the new blower motor by reversing the removal steps, ensuring all connections are secure before reattaching the battery.
How do you install a heater blower motor in a 1990 Lincoln Continental?
Do you already have the old one out?
How do you replace blower motor resistor on 2003 Nissan altima?
One can replace blower motor resistor on 2003 Nissan altima by removing the old using spanners and replacing it with a new one.
how to change blower motor in 1992 acura legend?
To change the blower motor in a 1992 Acura Legend, first disconnect the negative battery cable. Remove the dashboard panel or glove compartment to access the blower motor, which is typically located under the dashboard on the passenger side. Disconnect the wiring harness and remove the screws securing the blower motor in place, then take out the old motor. Install the new blower motor by reversing the removal steps, ensuring all connections are secure before reassembling the dashboard.
How do you replace a 1996 Acura TL blower motor?
To replace the blower motor in a 1996 Acura TL, first disconnect the negative battery cable to ensure safety. Remove the glove compartment to access the blower motor housing; this typically involves unscrewing screws and detaching any clips. Once exposed, disconnect the wiring harness from the blower motor, unbolt it, and then remove the old motor. Install the new blower motor by reversing the removal steps, ensuring all connections are secure, and finally reconnect the battery.
How do you replace the blower motor in a 2005 Chevy cavalier?
To replace the blower motor in a 2005 Chevy Cavalier, first ensure the vehicle is off and disconnect the negative battery terminal. Remove the passenger side lower dash panel to access the blower motor, then disconnect the electrical connector and unscrew the mounting screws holding the blower motor in place. Remove the old motor, install the new one by reversing the steps, and reconnect the battery. Finally, test the blower motor to ensure it operates correctly.
