answersLogoWhite

0

Check pressure At idle 13-20 psi With ignition on and not running 23-31 psi

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Where is the fuel pump on a 1995 Chevy lumina apv?

in the gas tank


Where is the fuel pump on a 1991 Chevy lumina apv minivan?

I have a "94" apv. The fuel pump is in the fuel tank and is one of the simpler ones to replace,and reasonably cheep at $60.


Location of fuel filter on 1993 Chevy lumina apv van?

Should be in the fuel line, near fuel pump check it


How do you empty out the fuel tank on a Lumina APV?

Get a syphon hose


When was Chevrolet Lumina APV created?

Chevrolet Lumina APV was created in 1989.


Occasionally when first starting your 91 Lumina APV you have to pump the gas for up to 30 seconds or more to keep it running then suddenly the van will take off and idle normally?

Change the fuel pump.


Will a bad ground on a fuel gauge cause it to dance around on a Chevy lumina apv?

Yes.


Where is the fuel filter on a 94 lumina apv?

On a 1994 Chevrolet Lumina APV, the fuel filter is located along the frame rail on the driver's side of the vehicle. It is typically mounted near the fuel tank and can be accessed from underneath the vehicle. Be sure to relieve the fuel system pressure before attempting to replace the filter for safety.


1995 Chevy lumina apv van with 3.1 liter engine your engine wont stay running you have to play with throttle to keep it running you have changed fuel pump fuel filter coolant temp sensor fuel injector?

change the thorttle responce


Where is the fuel pump relay switch on a 1991 Chevy Lumina APV minivan?

BEHIND RIGHT HEADLIGHT STARTING CLOSEST TO RADIATOR SHOULD BE 3RD ONE OVER 3.1 V-6 ENG


Where is the fuel pressure regulator located on 1993 Lumina APV 3.1L?

the fuel pressure regulator is located behind the drive belt close to the top


94 lumina apv 31 fuel pump relay and fuse all are good but wont power up when key is turned on what can you do?

If the fuse and relay are good then there are only 3 possibilities. Either the wiring to the pump is bad, the pump is defective, or in rare instances, the computer has failed.